When conducting a summer holiday in the villas, it is quite good to have a private pool on the site. At first glance, building such a structure is expensive and requires months of manual labor. In fact, make a large swimming pool with your own hands in 1 day, without having not spent.
Materials:
- pallets;
- any board;
- Plywood, OSB, DVP, MDF and or other sheet material in any condition;
- dense polyethylene film for greenhouses;
- Packaging film trimming, corrugated cardboard or substrate under laminate;
- nails or self-tapping screws;
- sand.
The process of building the pool
By choosing a place under the pool you need to clean it from weeds, stones and other protrusions. The construction site is pretty shovel and levels into the plane.
After that, the pallets are exhibited at its perimeter to form sides of the pool. By building the 2x3 Pallet Bowl of them, you can get a swimming pool with a capacity of 9.5 cubic meters. water.
The cutting board is stuffed on top to the pallets to combine them together.
After that, they are cooked on the outside by any available lumber, you can use the unedged board. A solid covering is not required, it is necessary to simply give the design sufficient stiffness so that it does not spread it from the mass of water.
From the inside the framework of the pool is trimmed with any sheet material. It is necessary so that the film laid in the future does not break. In parallel, the bottom is sweeping sand.
If the inner cover is made of coarse crop, then to smooth their edges, it is necessary to climb it with a substrate under a laminate or packaging pupil film. You can use corrugated cardboard from boxes. If the cardboard also stacked on the bottom of the pool, then it is desirable to put a thin film or an old polyethylene tablecloth so that it does not rejoice, and ants are not blocked.
Next, you need to prepare a film to seal the framework. Used the usual cheap polyethylene film for greenhouses. Under the framework with the sides of 2x3 pallet, you need to take 2 trimming of the film 3x7 m and solder them together. For soldering, they are stacked with overlap 15-20 cm and stroke the iron through the newspaper. From this polyethylene melts and weld among themselves. Then the film is placed in the pool bowl.
Immediately you need to turn on the pump for injection of water, as it will climb longer than the bowl itself is built. In parallel with this, on the outside, you can see the frame with a color film to protect the boards from moisture and make the pool more representative. On the side of it leans the ladder. As a result, from 10 pallets, a cup of 2.4x3,3x1.2 m is obtained, which makes it possible to bathe with convenience to several people at the same time.
