From this master class you will learn how to make a miniature hat By rim do it yourself.
It is necessary to prepare the following tools and materials:
- Close scissors;
- Scissors "Zig-Zag";
- tweezers with acute ends;
- simple pencil;
- Circle;
- threads for sewing;
- needle for manual sewing;
- line;
- glue "Moment crystal transparent";
- feathers of cesharok, different sizes, 5 pcs.;
- cardboard dense, size of about 15x15 cm;
- Cylinder cardboard;
- white lace with a large pattern;
- Lace black narrow, 1.5 cm wide, with one festral edge;
- beads pearl milk and pink;
- a ribbon silver width of 4 mm;
- tape white satin width 2 cm;
- dense glue gasket (shabrak), measuring approximately 15x15 cm;
- Knitted black fabric in fine white peas;
- Boujin black large.
Consider the sequence of the manufacturer of the Hat.
From the cardboard and the shabraka cut the circles with a diameter of 13 cm. Shabrak we stick to knitwear with an iron.
With the help of Scissors "Zig-Zag" process the outer cut of the circle. This will avoid squeezing fabric.
The hat is designed for dressing on the rim, it will be attached to it by loops from the tape.
Simple pencil is placing the location of the slots under the loop on the involving side of the workpiece.
On the cardboard cylinder from the end side we glue the bottom of the cardboard. From the knitwear, cut the circle, the diameter is equal to the diameter of the cylinder + 2 cm.
We stick a knitcle circle on the donyshko cardboard cylinder.
From the knitwear we cut the strip. Its length is equal to the girth of the cylinder + 1 cm, the height is the height of the cylinder + 2.5 cm.
The upper longitudinal slice band must be found by 1 cm.
We stap the band in the ring (on end sections). Seams are trimmed.
We stick knitted blanks on a cardboard cylinder.
The lower sections are wearing the inside of the cylinder.
We measure the length of the circumference of the cardboard blank under the field of the hat. For this value + 2 cm we cut the band from knitwear. Its width should be equal to the radius of the fields + 1.5 cm.
One longitudinal slice started by 1 cm. Strip sewing into the ring.
We glipulate the lane to the cardboard billet (from the wrong side). Then on the front side of the fields we collect a knitwear band in small uniform folds. If the thickness of the cardboard allows you to fix them by flashing through the cardboard. At the outer edge of the fields of the hats, the black narrow narrow lace is seized in small folds.
We glue the cylinder on the hats fields.
We decorate a white hat and black lace.
On top of the lace stick beads. Here you can use tweezers with acute ends. It is convenient for them to keep the beads, dip it in glue and glued to the right place.
In the next step, we glue (you can also sew the secret stitches) feathers of the workarians.
From a white satin ribbon we make a miniature bow, from a silver ribbon - tails to it. Bantian glue on the hat. A large black bead can be glued to the center of the bow.
Larger and high feathers glue closer to the back of the Hats, and smaller and short - closer to the front.
In the harvested lower part of the fields, we make a slot under the hinge on the markup. In these slots insert the hinges from the silver ribbon. We glue them. Then we lingify the bottom of the fields to the Hat.
Hood hat! Now it can be put on a narrow black bezel and decorate its hairstyle.
A source