These earrings, similar to small robots, to make enough simply using wires of wire.
For the manufacture of similar earrings, you need a silver jewelry wire, a wire colors, pink glass beads, small pearl beads, round-rolls (they can be replaced, for example, on a thick nail or other similar piece of round), steel knitting needker or a piece of steel wire and steel wire and Lubes.
At the beginning, we will make 16 small spirals from the wire. To do this, we wrap the wire on the knitter, then remove it (wire) and apply to short spirals for 7-8 turns each.
With a small piece from the wire, a small piece (13-15 cm) and we will make the middle of a half turn around the lip of the rounds.
Remove the wire, the rounds are set aside, at the next stage they will not be needed.
For each free wire end, we put on two wire spirals with a pearl bead between them. It will be the legs of the future robot, and pearl beads will portray the knee joints.
Next, both ends of the wire fold together and put on them a pink glass bead that will be a body for a robot.
Now make a robot hands. The ends of the wire wept in different directions and put on each wire spiral and pearl beads.
We take the round row and next to each pearl beads, we make a turn around the lip. The turn should be done in such a way that as a result, the end of the wire looked into the opposite side of the body.
Then we put on the "hands" on one pearl bead and one helix. After each end, the wire turns to each other.
Now we put on every end another pearl bead. We connect the ends together and put on them "head" in the form of a glass bead.
The whole previous process of working the robot lay my legs up, now it will turn it over. One of the ends of the wire woven around the "head" in three turns with an equal step between the turns, they should be located on a bead, and not over it and take half of the beads. The remaining "tail" will be spinning into curls.
The second end will be shine in the loop, pre-biting the excessive wire length.
Since the hands of a robot are a bit short and they lack mobility - we will make a moving continuation. To do this, take a glass bead and put it on a small piece of wire. On the edges of the wire will make a loop. Now join each hand on one such bead, clinging them with loops from either side of the beads to the loops on the hands of the robot.
Now we will make a twin brother's robot.
They get them on Schwenza and that's it.
A source