I propose to make a decoration for shoes or sandals.
We need:
- Natural skin thin
- PVA glue
- Glue moment gel
- Wire
- Laman
- scissors
- Dotted contour on fabric
... and the desire to make the decoration :)
Flower size is at will, so you can make molds of any size.
Leaf and petals I have a single size.
We supply a handle of 6 petals on white leather and 3 leaflers on green leather, cut out.
The flower will be attached to shoes, so the carved petals must be soaked in glue to be fine, so that the shape is well (1 of the glue of PVA + 2 parts of the water). If the flower is for other purposes (hairpin or brooch), then you can miss just good with a brush.
Let's get the petals and press well in the fist, then we will straighten and give a little to dry up so that the glue is not visible.
Petals dry up, make stamens for lily. We take the skin thoroughly 1mm and cut out as in the photo, the length of your desire.
We make a pestle with a length of 5-7 cm, too much will go to the barrel of lily.
On the finished pestle we glue the stamens. For a flower in decoration, you can apply ready-made stamens.
On the petals of glue is not visible, otherwise it will be bad to add petals (slips).
We fold the petals along and tighten on your finger, the handle can be immediately in the tube.
We leave to dry "until half ready.
Petals are almost dry, but it is even easily possible to stretch them. First, in the center in the width, pull, then pull along around the finger so that the form remains semicircular, as in the photo. Now I'm already seeking ready. You can dry in the oven preheated with an open door or a hairdryer.
We start sticking the petals by glueing the moment in the places of the specified arrow.
We glit first 3 petals, then the following 3 on top and in the intervals between the petals.
Third row glue green leaves.
Flowers are ready for us, you can pull the petals, holding at the base, giving them a more beautiful form.
Take the outline and on 3 petals we do Krapin, I was at hand yellow.
Cut the two petals (we will glue the flower on it) and two strips (they wrap the stalks).
Lubricate glue those parts where the base and the skeleton will touch.
The stalks are glued and bend horizontally, and the flower should look up.
This is the easiest way to decorate shoes, stick it "tightly", if not sorry shoes. You can make a pin or clips.
Here they happened!
A source