Materials and tools:
Soap base (transparent and white, or transparent and titanium dioxide);
Glycerol;
Alcohol;
Basic oil (any);
Dyes (pigment or pearl, not migrating): lilac (red or other, rose color), green;
Fragrance or essential oil: rose;
Forms: Hemisphere, oval 3D;
Knife for cleaning vegetables;
Board.
1. Make a blank for roses
We take 60-80 grams of the soap base, cut into cubes, we melt.
We add glycerin 1 h. Support, pigment (and / or mother), it is desirable to add titanium dioxide, or take a transparent and white soap base 1: 1. In this case, the rose will be more clearly visible in the finished soap. In this master class, the option is only with a transparent basis and without titanium dioxide. In the title photo - a variant with titanium dioxide.
We pour into the form of a semisfer (you can replace any round shape, I like the option with a hemisphere more).
Leave cold.
2. Making leaves
We take a bit of the base, we melt, add titanium dioxide, glycerin, green pigment, all stirred and pour onto the board, or any other flat surface. Sprinkle with alcohol if there are bubbles.
We give cool, it will happen very quickly.
Further, anyone convenient for you tool (stack, knife, toothpick) draw the contour and the texture of the leaf. Kontuctors we carry out to the board, the texture is gently drawn, slightly pressing.
Separate leaves from the board, for this you can use a knife or stack.
On one rose you need 5 leaves.
3. Making a rose
Pull out a soap half factor from the form. It should not be completely cooled so that the petals themselves glued themselves. We cut into 2 parts. 1 rose is enough to half the hemisphere.
Cut half a knife for cleaning vegetables, as shown in the picture. Petals have in order, it will be more convenient to collect a rose.
Next, we collect a rose: we take the smallest petal and twist it into the tube, then take the second and turn around the first and so on.
In this way, we collect all the petals.
Rose is obtained with a recessed middle. Further flexing the petals, as if revealing a rose.
4. Printe leaves
I calm the foundation, immediately for everything remaining. Add basic oil and flavoring or rose essential oil into it.
I turn over a rose, spray it and leaflets with alcohol, drip the base and glue the leaves, as shown in the picture.
After the leaves are glued, you need to put a rose in the form of 3D to make sure it is to fit there, if not, the leaves can be adjusted or cut.
5. Pour rose
We put a rose on the board, splash with alcohol, and pour the foundation into it, it is important that the basis is not hot, otherwise our rose melts, we wait until the flooded base will fit so that the rose can be flipped.
In 1 half the detachable form pour the basis, somewhere up to half, splash with alcohol, then splash the rose with alcohol, and immersed in the molds of the leaves up.
We are waiting until the base challenges so that the form can be put up vertically.
I spray with alcohol, close the form. If the form is connected not tight, we are tightened by the shape of rubber. Fill the basis, the basis also should not be hot.
Let us completely cool. Pull out of the form. Cut extra.
That's all!
A source