The author of the work is Lena Dianova (Diamondshop).
Today I want to tell you how to make a beautiful bracelet using stone (I have a druss of agate), a suede cord and silver plated wire in the Wire Work technique.
So, we will need:
- Tools (round bits, nippers, pliers);
- Wire (with silverness - so the decoration is to serve much longer than if we take the usual wire);
- Sushin cord (24 cm)
- 4 connecting rings (they can also be made from thick wires);
- lock;
- the extension chain;
- Star suspension.
Baister!
Take the stone, we draw the wire. I have a 2GA wire thickness label (0.51 mm). Such wire is best suited for twisting in our bracelet.
Then the round-rolls make a loop and turn the wire several times at the base of our loop. We make a second loop in the same way. That's what it turns out:
The number of turns must be treated to do the same. So more beautiful!
Now we take a suede cord, cut off the four equal lengths along the length of the segment. You can cut the stringent, and then "fit" by hand. Or immediately try on hand and cut off, as I did. On my wrist 14 cm I needed a segment about 6 cm. Do not forget that the stone also has its length.
Then twist our wire for two cuts of the cord. It is necessary to twist so that the loop of the wire is formed, which we can subsequently connect with the shell obtained on the stone. So, we cut a wire with a length of about 8-10 cm, bend in half, in the middle we form a loop. Then we apply one end of the wire at once to two suede cords, a loop, along with the cords, keep pliers and the hands begin to firmly wrap over the second end of the cord wire along with the first end of the wire at the base of the loop. Wire ends are cutting with nipples and hide in the winding. As a result, we had two "strap" - on the one side of the stone and on the other, like on the clock. Such a winding firmly holds cords together!
We take connective rings and connect a loop on a stone with a loop on the cords on both sides.
On the other side of the cord, where the clasp will be attached, we do the same. We make a loop, winding out of the wire and krepim one connected ring.
Connecting rings can also be done. I would advise you to make them out of the thicker wire, for example, 22 GA (0.64 mm), so they will be stronger and you will have confidence that the bracelet will not break and not lost.
On the one hand to the connecting rings, fasten the lock. On the other hand, the chain and decoration in the form of the stars.
Decoration ready!
For beginners, I plan to make more master classes for the manufacture of connecting rings, on step-by-step making winding and winding with loop, as well as on the manufacture of the loop itself with the help of round-heads.
A source