This night light will be the subject of decoration and raising mood. Make your own hands such a lampshade is very simple. And most importantly, he will also become a good gift.
Materials:
- energy-saving lamp (not a regular incandescent lamp!);
- plastic transparent bottle with a capacity of 5l;
- plastic spoons (approximately 175 pcs.);
- Yellow and green paint for plastic / acrylic (can be luminous);
- plastic bottle for deciduous part;
- cartridge;
- plastic tube (diameter, which is lamps lamp lamp);
- shears for pipes / pubsik;
- plywood;
- wood varnish;
- sandpaper large and small grain;
- steel wire;
- PASSATISIA / FLAGES;
- Plastic clamps;
- copper wire (cable);
- pencil;
- drill;
- the car on the tree;
- a hammer;
- Chisel / Crantsmeysel;
- sharp knife;
- Wooden round sole (can be cut by a jigsaw);
- scissors;
- switch;
- Super glue.
Step by step:
1. Smoothly cut the bottom of the bottle to a sharp knife. If necessary, to compose irregularities with scissors.
2. Cut the heads of spoons from the handles.
3. Paint them in two layers.
4. Give dry.
5. Printed spoons using a minimum amount of glue, circular rows of chess order, starting with a slight indent from the lower edge of the Bottle Frame. It is a second row of spoons glued in intermediate areas of the first row, placed on the brass.
6. Cut the shape of a star from a green bottle (or pre-painted). Bend into the shape, framing the top of the lamp.
7. Glue the star of the lampshar.
8. From the same bottle, cut the leaves in the form of a spear of different lengths and bend them in the middle, giving the appearance of tilt.
9. Apply the glue on the base of the leaf and glue, bend the leaflet of the book, closing the plastic bottle cover in a circle.
10. In the plastic pipe to expand the hole under the cartridge with scissors / cutter. The diameter of this premium must correspond to the size of the cartridge (so as not to be loosened).
11. Attach the wires to the cartridge.
12. Insert the cartridge into the hole in the pipe.
13. Screw the light bulb.
14. Steel wire bending (construction by type umbrella) under the lampshade. At the same time, the rods of the rod should be greater than the laundrut of the lamp (the principle of spacers).
15. Make the required number of struts from steel wire according to p. 14.
16. Breeping struts on the outer surface of the plastic pipe clamps, the fastening portion of the strut completely closes on the pipe.
17. Tails of the clamps to trim down with scissors.
18. Make passatages the same length of the Wires of the backup.
19. Cut the fruit / saw platform from a tree.
20. Place the pencil at the bottom of the platform to communicate under the wires, tube and switch. Cut out the chisel + hammer or cracmere.
21. Drill the openings of two diameters in the middle for the pipe (more in diameter), which goes on half the height of the wooden platform, the rest is drilled for a narrow hole assigned to the wire (smaller diameter). Also make a hole for the switch. You can turn off immediately from the network - then the switch is not needed.
22. Collect the platform with emery paper of two types.
23. Insert the plastic pipe and the wire into the corresponding holes on the platform.
24. Install the switch.
25. Apply lacquer on the platform.
26. Cut from plywood cover on the bottom of the platform.
27. Glit Paneur to the platform, hiding communication.
A source