Let's proceed.
We will need: Foamiran, scissors, superchalters, floristic wire No. 28 in the winding, 2 curly holes (the second photo will be lower), the tapes, tape ribbon, the needle is about 1mm thick (I have a tapestry).
For one twig, we need 27 flowers, respectively, cut 27 pieces of wire, five long-long pins (depending on the desired twig size), the remaining approximately 5-7 cm. Throwing on one end of the wire tiny loop.
Figure holes cut the flower blank. For one, we need 4 octivers of eight-graders and 2 four hundred. On a twig of 108 eight-graders and 54 four hundred.
We put an eight-chain and loop on the wire at the end a little plunge hot glue (I insert about 1-2 mm right in the spout).
In the photo size droplet glue:
And quickly, while the glue was cooled, crimp the eight-chain around the loop with a drip of the glue. We can turn between big and index fingers (like rollers) until the Fom becomes thinner.
Then we live on the wire three more eighties.
We promote them upstairs.
And again rolling between your fingers until the Fom becomes thinner, like this should turn out:
Now we take a needle and four hundred people. We put the needle to the center of the workpiece.
Gently crimp a fom along the needle. Turtle between big and index fingers again.
So do with all other four hundred. We ride on a wire with a flower 2 treated four hundred. I drip the half of the droplet superclone under the base of the flower (marked with a black marker) and glue one and second flowers, petals should be shifted relative to each other (in a checkerboard).
I hope everything is clear in the photo. Such flowers for one twig make 27 things.
Here they are, our bubs:
Tape ribbon connect together three flower.
We again connect three three flowers this time.
And we collect all bushes in one twig.
We grind flowers, and our twig is ready:
Four twigs are connected here:
A source