Old floor lamp, and not just old, but also a fairly new floor lamp, you can upgrade or decorate with decoration of a flap. If you like this idea and you are ready to try, you can do it, guided by the master class given below.
For the decor of the ceiling, you will need a fabric with a pattern (you can have several types of drawing) and one-picture fabric, glue (better moment - liquid nails), threads and needle. To make the pattern you will need centimeter, paper and a ruler.
Initially, the ceiling was such - completely unattractive. In order to make the pattern, you need to change the length of the bottom circumference of the ceiling, the top and height of the wedge. There are 10 wedges on this ceiling, and you can make another number - for example, 8.
To obtain the distance and divide the length of the upper circle to the number of wedges, and to obtain the distance B - the length of the lower circle to the number of wedges. The height of the wedge is drank. Introduction for seams in this case do not do - the seams will not be here.
Put the desired number of wedges from the same tissue or from several types of fabric.
Position the wedges on the ceiling and stick them. Only dense adhesives are suitable for gluing, which do not absorb tissue. For example, "moment" - "Liquid nails".
Now the plander looks like this.
Now you need from monophonic fabric to carve two more wedges - as the top wedges will be double. This time putting the allowances on the seams, but only on the sides. From above and below, the allowance is not needed.
From the offline, make up the side seams, remove the wedges and join the iron.
Measure the middle of the side and sew them among themselves, as shown in the figure below.
That's how it should look like.
Now take the wedges and place them on the ceiling over the paste-colored wedges. The middle of the monophonic wedge must coincide with the joints of colored wedges. Sew them with hands to the top edge of the ceiling.
Now fasten the lower edge of monophonic wigs so. So that the sides were on 1 centimeter are wrapped in front.
From above and bottom, cut the plafof with a plafo from a monochon tissue.
Here is such a result should you get!
A source