For the manufacture of a broches tie will be required:
- Satin tape 3.8 cm wide;
- a lace tape with a width of 3.8 cm;
- brooch, rhinestones, semi-graysins and another decor;
- hot glue;
- scissors, lighter;
Tie brooch step by step:
Usually I do not adhere to the sizes and cut everything on the eye, just for MK decided to measure everything.
Prepare billets for the tail. One length of long 26 centimeters, three tape segments and three segments of lace on the 15th centimeters, six segments for the smallest details of the 13th centimeters.
All segments need to be folded in half and solder on the edge, while three segments of tapes, which need to be folded with 15 cm with lace and also to deceive or sew.
We fold the tail. First we take the longest segment and begin to glue shorter billets in this order as in the photo.
Next, make the blanks for the bow itself. One segment 30-centimeters, four cuts of tape in 28 centimeters and two segments of the lace of the same length, a segment of tape and lace in the 25th centimeters, cuts of tape in the 15th centimeters.
Glue the workpiece, as in the photo. And the edges can not stick with each other. And so that the middle was empty, that is, glue through 1-3 cm after the bend. It turns out not so heavy and thick. On the photo, only one side, not inverted ... There is a lace so glued, and it is very thick. Externally, it is not visible, and the product turns out thinner and easier.
We glue with all parts with a hot glue and then stitched, as in the photo .... after gluing the blank with brooch.
Connect two elements with each other and glue. Tie gluing hot glue, tape width 3, 8 cm. At the end, you need to glue the base with a pin.
Finished tie brooch, view from the wrong side!
The author of the work is Tatyana Plotnikova.
A source