Master class from Natalia.
The thing I will sew today, demonstrating the process in this master class, is a fairly useful and functional accessory. It can be used as a wallet or as a holding-limiter for documents. Or how together together at the same time. The organizer will have a variety of compartments: two large for bills, tickets, road maps, the necessary pieces of paper, checks and the like and one large vertical, there is a passport, for example, there will also be a zipper compartment and three small compartments under plastic cards. The whole design will be closed on the magnetic button.
So, for our work, we will need cotton of two or more different colors, seal, button and zipper. The number of cut parts and sizes are shown in the following photo:
Let's start with a pocket with a zipper. Lightning cut up to 10 cm. Crow small squares and market the edges on the wrong side.
We proceed the ends of the lightning, facing them bent in half the squares. You can read more about this manipulation in the previous my master classes, for example, here >>
We enhance zipper in your pocket using the parts 34 cm by 12 cm.
In the same way, we sew the second edge of the zipper, we turn and exparate pockets.
We apply the pocket to one of the parts 22 cm by 12 cm and add the bottom edge, retreating approximately one cm from the edge of the tissue.
We take the second part of 22 cm by 12 cm and compress it with a pocket along the long edge.
Holder's left pockets are ready. Now we will deal with the right side. Stool the face to face 10 cm by 22 cm on long sides.
Deploy and disappear them. We apply to the third part 22 cm by 12 cm and the marker is carried out for the card pockets at a distance of 7.5 cm and 14.5 cm.
Street through the lines.
We finish your pocket, sewing the last, 4th part 22 cm by 12 cm to the corresponding edge of the third.
Deploy and excavator.
Pockets are ready. Now we put the magnetic buttons, aligning the parts of the seal and cotton on the purse and on the outdoor side of the wallet.
We finish the hlystics, facing it around the perimeter the second item, putting it face to face to the part with the button.
Soak and move away.
We proceed to the final assembly. Unlock pockets on a large piece of lining as they should be located in the wallet.
From above face down put the part of the face with the seal.
We grasp the perimeter, leaving the turning hole.
Instruct, we move and sew a manually hole.
Holder is ready!
A source