Such a pouf has wheels for mobility movement, and the upper part of it is a cloth. If you have a lot of shoes, you can increase its dimensions at your discretion.
You will need:
- 3 parts, size 600 x 600 mm 12 Millimyt wood - base / sides / top
- 8 parts 160 x 200 mm of 12 milliber wood - separation elements.
- 3 x 35mm screws for wood
- White plastic caps on screws (16)
- Olemy and white color spray
- 4 rollers and small screws
Instruments:
- A hammer
- Drill
- Glue
- Clips
- Roulette and pencil
- To choose from: fabric, upholstery and filler under the fabric.
You need to draw circles on three wooden details.
With the help of a mechanical jigsaw, cut the circle along the pencil office.
Coloring the sides of the circles so that the paint goes to the greater. Draw the inner circle on the board. The circle should be about 170 mm from the edge of the product to place the dividers of 160 mm in the width. Position each separation part in turns diagonally. So that the inner edge coincides with the inner circle. With the help of roulette and pencil, mark 40 and 140 mm respectively.
Drill 2 mm holes at points of circles, for the tops and base, as well as drill the top and bottom of the separation parts. This will provide you with a easier assembly.
In the finished holes, place screws.
On the back of the circle, install each separation part in turn and screw to the base. Screen on both sides, then go to the next part.
In the central circle, repeat the previous steps. Now turn the circle and draw new diagonals, between already battered lines. Drill 2 mm holes and install screws.
After you attached a central circle to the base (separating elements), set the second layer of separation elements to the central circle. Drill the central circle below.
Now time to connect the upper part with separation elements. Before screwing items, make sure that they are correct and smoothly located. With the help of glue, glue caps on all screws.
For painting used paint from the canister. Colors olemy and white satin. Since paint is quickly absorbed into the cut edges, treat them with several layers. Then proceed to the remaining surface. Give each layer to dry and only then apply the following layer. Do not apply too much paint, since it is formed from a thick layer.
As soon as the pouf shelf dries, turn it over and attach the rollers. To put the tissue under the top base, which would not scratch the paint. This is a pouf-shelf without a cloth upholstery.
Go to the upholstery of the top
In order to be gently sitting, cut out the material of the same size as the range of bases.
Cut 4 parts from batting the same size and two smaller. So it turns out a small hillside on the top.
Now you need to cut the fabric with a diameter a little more than a circle. Building stapler fasten the fabric. The upholstery tape will be an excellent alternative to nails that need to score, fixing the design.
And here is our finished pouf shelf for shoes.
A source