In this master class, I will talk about the manufacture of the belt belt.
The tool that we need:
1. Hammer
2. Rotary knife
3. Knife
4. Shil
5. "Canvaskorez"
6. The Staff of Begunder
7. Pobbin for holes (for seam)
8. 3 mm Punch for fastening buckle bunches.
So, we have a buckle (purchased ready).
The belt band of the desired size is cut off (in my case it is 110cm).
First, cut the tail of the belt, as we like it more (you can make a preliminary pattern from cardboard).
Now we will deal with the part of which the buckle will be attached. The skin is 4mm thick. Cut 1-1.5 mm. (For a length of 70mm), and in the middle part where the buckle frame will be held a little more (I have not done this groove in the photo).
Since I do the belt for the desired size, the buckle decided to sew tightly. To do this, we make a groove under the seam. First, they make a "canvas", a groove under the seam of a long 15mm, then the pass of 20mm (under the buckle frame) and can continue to the end of the belt.
There will be embossed on the belt. The chosen the theme of the rune. We apply them at the same distance pre-selected, then cut through the rotary knife and can be crowned. To highlight the contour, use the beggar stamp. Before you close on the opposite side of the belt with glue painting tape (otherwise the belt will deform), wetting the strip until it stops to absorb (like a sponge) water, let it dry (in order for the skin from above to acquire the color similar before you wipe it) and you can close ..
The place between the runes is a close stamp for making the background.
Cover the strap soil (in my case it is Kenda Farben Prefondo) let dry and apply the finish (Kenda Farben Appretto Super). Appretto Super betrays gloss.
Next, we make holes for holes for holes under the seam in our groove, (1 tooth of the band, I always put in the already made hole, while the rest will do on the new ones). In order not to hang a pad under the belt we put unnecessary skin trimming, and to make it easily piercing the holes and remove the supplement you can move it to wax.
And begin to flash our belt, I use the saddle seam. Thread waxed black 1mm. We start with buckles, wrap our skin on the Rametark, to finish the belt there is where we have ends with skin thinning that they did.
We make holes of the desired size for the hook of buckles. They make small notches to better sell a bunch (notch must be made in the opposite side from the tail of the belt).
And here is ready job.
MK from Alexander.
A source