We continue to sew this suit.
At the previous part we sewed a sweatshirt to this suit.
Now proceed To tailoring pants.
Panish pattern.
Strip details. I made 0.7 cm in the seams (on the wider lines width).
Step 1. Mix or spin the front and rear halves of the pantian. Step parts.
Step 2. One pant is turned on the front side and insert into the other, combining the average front cuts of parts and the middle rear cuts of the parts.
Step 3. Mix or pick up the middle sections and steal the parts.
Step 4. Make the cuffs on the pants in the same way as the cuffs on the sleeves of the sweatshirts.
Step 5. Cut the belt and cut two corners. It is necessary in order to arrange a hole for taking gum.
Step 6. Overlaying these sections.
Step 7. Stead the belt in the ring as shown in the photo.
Step 8. We fold the belt in half (in width) and start.
Step 9. The belt obtained 2 sides: the facial and invalid on which it is with the treated hole. We apply the front side of the belt to the front side of the pants and take it or pick up the pins. Hole for gum must be behind. Apply the belt.
Alternating into the belt, rubber bands and pants are ready.
Here is a suit with us turned out!
A source