MK Air Bowl
I want to tell in detail how I make such bows.
We need a ribbon width of 5 cm glue I use the moment of a thread crystal under the color of the ribbon needle Beads to decorate a ruler and needle for fixing, but you can do without them.
We cut the tape of 12 cm and we are cutting the edges with a convenient way to you. I use the deceit. For this banta, we will need 17 pieces.
We drive the corner on the wrong way as shown in the photo.
I turn over the front side and bend the corner.
It turned out a triangle that folded in half and fix.
We do the same on the other side.
We flash the corresponding seam without cutting a thread.
We fold the future petal facepiece inside.
We are tightened and fix the thread the tip of the thread.
We put the edges and here it turned out we have such a petal.
Now you can start assembling a bow.
The first row of 8 petals wear smoothly in the center.
We form a row. In this case, making the petals through the first petal, clip cutting and wept the thread.
The second row consists of 6 petals.
The third row consists of 3 petals. We dress on the thread, but now it's not in the center, but slightly retreating about the edge of about 2 mm.
Fix the thread cutting down.
Running petals slightly spinning back and that's what it turns out.
Wash the corners with glue and fix.
Connect layers.
That's what we did.
We glue a rubber band.
That's what is happening with the inside.
We make our bow of beads.
Our bow is ready.
The edges can be painted by sequins. Thanks for attention. I hope described everything in detail.
Share-star.
A source