A variety of genital types for the garage are known. Wooden floor is one of the simplest and most convenient options for both manufacturing and in the process of use. In addition, wood always gives a feeling of heat, in contrast to concrete surfaces. Observing technological techniques and following the right advice, any owner will make the wooden floor in its garage, capable of daft to once. Further considers the process of performing work in the case when the floor is an earthen surface.
1. Required materials and tools:
- Wood hacksaw;
- Construction level;
- A hammer;
- Bar wooden 100x100 mm;
- Boards with a thickness of 50-60 mm;
- Rolled bitumen material;
- Nails or self-tapping screws;
- Antiseptic;
- Gravel.
2. The surface of the earth is spilled, the pillow of a crushed stone with a thickness of 40-80 mm and is thoroughly tamped. Dimensions are removed and the scheme of the future coating is drawn up. It is recommended to put lags across, and the boards along the movement of the car. Along the walls, the slots are left 20-30 mm.
3. The lags of the required length are cut from the bar, which are processed by an antiseptic for three passages. After a complete drying, the lags are installed in place in increments of about 30 cm. Under the bars, the backrueroid is pre-plated and they are aligned with the level of construction.
4. Thick boards are collected according to the desired size, and then soaked with the protective composition from all sides. Next, the genital boards are fixed through nails or screws. There are 3-6 mm gap between adjacent boards to improve the passage from the bottom of raw air.
Wood is a material subjected to rotting. Therefore, in the garage with a wooden floor, you should consider the device of good ventilation. It can be both natural broach and use of special exhaust devices. A detailed idea of the intricacies of execution of work can be obtained after watching the video shot by the craftsman, made the wooden floor in its garage.
A source