For light dresses without a collar and sleeveless sleeves with a short shoulder line, it is extremely convenient to use a single combined chain processing and a preach, which provides a particularly smooth facial side of the product and a beautiful, comfortable in the wrong side. Processing such a slap at first glance seems puzzle. But, if you decompose the process in steps, everything will turn out to be much easier that I will try to demonstrate now.
Combined wrappers are called so because the sections of the neck and the armor are treated and cut out of one flap of fabric.
Still all vertical seams of the product, but do not sharpen shoulder seams.
Prepare parts of the hopper.
This is a backrest cover consisting of two parts, since the middle of the backs, as a rule, there is a cut under the fastener.
And the wrap is transferred to one detail. In the photo on the left, the wrapper with the seam in the middle, but in this particular case it had to cut out due to the lack of fabric. If the fabric is in sufficient, exhaust the ottolkuchka of the transfer.
If the patterns of the calculation parts are not included in the kit of the finished patterns or you built the pattern of the product yourself, make the patterns of the sheets using the shelf and the backs. To do this, draw a garbage on the details of the pattern. The width of the wrap, taking into account the allowance on the seam in the narrowest place, should be at least 6-7 cm. Also, the wrap should not extend to the bust area and blades.
Fold and sculpt all available build or folds on the pattern of the product in the area where the hopping will be. Print the pattern on the leaf of tracing or any other suitable paper. Copy roller circle the edges of your future wrap, copy all the marks, swipe the equity line.
The width of the allowance when cutting out the parts of the calculation should coincide with the width of the corresponding allowances on the main parts. For example, the lines of the neckline of the product - 1 cm, the same allowance lay along the throat of the calcination.
All parts of the wrapper along with the allowances are punctured by phlizelin.
Check that the hints are accurately repeated the size and shape of the neck and the trick of your dress. Check them if necessary. The neck and the dresses are also needed symmetrical. If you have previously made the construction of the product, then you can not worry about this at this stage.
Read more about Osnorovka here.
On the details of the hopper, take the side sections. Run them. On an overwhelming or zigzag, wash the bottom cutting slice.
Fold with front and details of the back of the front facets and scroll. Under the zipping fastener, the ends of the wrapper are screwed to the front, so that its exposed edge does not reach the line of zipper of zipper by 5 mm. Print the bending to the neck.
Lightning cabinets Dresses Unscrew on the front and pin over the wrapper (this will provide the beautiful edge of the wrap after it is turned).
Cut the wrapper to the product, starting and ending the line 2 cm below the line of the shoulder seams (see photo). Cut letters slightly cut in the places of rounds to the line.
Remove the zipper and lightning buckles on the wrong side. Cutting the trick manually to the zipper flashes with small imperceptible stitches.
Stop to face shoulder sections of the transfer and backs (products, not hooks!) Outbreak of seams.
Slide your hand between the back and the sprinkle, capture your shoulder seam allowance and pull them out. Stop the shoulder seams on the hints (face to face). Sunburning seams. It is convenient to do this at the acute end of the collar block. Or, as they advise in the magazine Burda Moden, on a long handle of a wooden cook spoon.
Cool from the inside and stake the remaining open areas of the neck and the preach. From the wrong side, wash the edges of the neck and the armor, causing the seam onto the slap. Run from the wrong side of the neck and the dresses. Remove the mark. Watches are triggered by secret stitches to the lateral seams.
A source