Earrings with pieces of fur can add you a little charming wildness and supplement the ethnic image. They are very lungs and do not pull the ear, and when the wind blows, they tick the neck.
To make such earrings with their own hands, we will need:
- Small Fur Fur Laceteners, Natural or Artificial
- Small skin flaps, also natural or artificial
- Four beads, a pair of smaller and a pair of more (I usually use wooden)
- Schwenza
- Sewing needle and threads about tone fur
- Universal glue
- a pen
- Rule
- scissors
- Blade (you can also a sharp stationery knife).
How to make earrings with your own hands
First, take fur flasking, turn the pile down. We draw two rectangles, approximately a centimeter in width and two in length.
Be careful, you need to correctly orient these rectangles. As a rule, a fur pile is directed in one direction, and along this direction is the lonely side.
The placed rectangles gently cut with the blade. To do this, we stretch the fur with your fingers a little and spend several times on the markup line, trying to cut the skin, but not damaging the pile itself.
Now take leather flaps and cut two narrow strips from it, no more than two millimeters in the width. You can count the strips like this: to the length of the big beads add the length of a small bead and one more and a half centimeters, and then we multiply the whole amount into two.
We cut off the thread, about 40 cm, fold it in half and do the ends in the needle's ear, at the end there should be a loop.
We gently thread for the middle of the leather strip: we have done a needle in the loop and tighten.
And now we can easily turn our leather strip through beads. We ride on the needle at first a large bead, then small.
Weching beads down the thread, and then on the leather strip. It is necessary to make it so that a very small leather looping peeling out of a small beads, approximately 3 mm.
Withdrawn, you can now put Schwenza. We reveal the ring on Schwenz and do in the leather loop, then close. Usually, the Swedza is very soft, and to reveal and close the ring, just pressing the end of the scissors. But if you suddenly get rigid and stubborn, hand over with the help of pliers.
All the same with the leather strip, beads and Swenza we do again. And here we have two blanks and two pieces of fur, it's time to connect them. Pickles that stick out from beads, lubricate with glue and apply to the fur, approximately in the middle, the bead is close to the upper edge.
Here, too, you need to be attentive: the top and bottom are determined relative to the direction of the pile, take a look at the photo below.
We are waiting for the glue to dry, and then we will sew our piece of fur. Cut a thread of about 40 cm long, ingested in a needle, on the end knit nodes. Purify the bottom corner of the fur is close in the edge, the nodule remains inside.
Purify the opposite corner, the thread goes from the inside to the outside, as in the lacing.
Tighten the thread and continue to "cord" with small stitches. The main thing is to catch the fur for the very edge, so that the thread then was not visible.
When we get to the top edge, we make a nodule and hide the thread in the bead, then it can be trimmed.
We repeat the same operations with the second earring. Now they look almost ready, the final touch remained. Cut a leather strip of about half a centimeter width.
Lubricate a strip glue and make two turns around the fur, right under the bead. Cutting, carefully lining the tip.
All our fluffy are ready. Take care of them from the water and dust, if suddenly sleep - seize a frequent brush. And most importantly - we carry with pleasure!
A source