Biscorn - French Word, which is translated as a polygon, crooked. I like the biscorn more, so I will call it in the future.
The biscuretop is a pad with several unequal angles, but rather symmetric, and can serve as a needle. If it is beautifully decorated, then such a thing will be beautifully hanging even a Christmas tree. This is a very beautiful and elegant thing, as well as a wonderful gift. The biscuretop is of different sizes, but usually divided into small - 35x35 (40x40) crosses on the side and large - 70x70 (80x80) on the side.
I offer you a master class on the manufacture of a biscuretury, which I took a few months ago for the participants of the conference on embroidery on 7Y.RU
Biscorn, like any other needle, consists of 2 identical squares, which are then stitched by interfer and stuffed. The whole secret of unusual biscuits consists precisely in the technique of stitching.
So, for a start, I embroidered two identical squares. The top I was decorated with a beautiful, seerful embroidery from Just Nun, and the bottom embroidered only around the edges. The most extreme seam must necessarily be embroidered backstage, because when crossing two halves, the cloth is not pierced with a needle! Thread stitches two halves, capturing the stitches of the backstage of both halves alternately.
Beginning of work.
Beginning of two halves
At the end of the thread tied the knot and dragged the thread into the corner of the lower part. Falled backstitch thread in the middle of the upper part .... and the process began.
Large implementation of the seam
It is clearly seen here that the needle captures the bexts of the edge backstitch from below.
Own work.
We specifically show that it is clear that from the inside there are no traces of the seam, only the stitches of Backstic.
Corner close-up
So we reached the corner. See how unusual it looks.
Putting.
When it remains to sew the 1st side, feed the job. We sew the remaining unimpressed edge and cut off the needle, after hiding the tip of the thread.
Seving butchers and screed.
I tried different ways and came to the conclusion that it was most convenient for me to pull the biscorpore with a thread, secure the thread and only then sew a button. It is so easier to achieve the right form of the pads itself, as well as to center the location of the button.
My biscuretop is ready!
A source