Start, 1 part.
Cut off the excessive dremel, grind, polishing.
Luke view
Cooking materials for hatch - fitting
Shipping. The inner part of the hatch.
Front. Here you can solder everything you like.
Cut the rude.
Dremel with a metal brush - and tedious work. Remove dirt.
Grind, and try on a lighter. Fine. The main thing is not crooked.
Side view with a hermetic ring. Be sure to be petrol.
Almost ready.
We prepare the "rack" lighters - it will close the spring and the lighter will stand on it.
I use a simply coin - suitable size. From above - copper side.
Drills a hole - insert the bolt, on a soldering paste - a side
The bottom is the cut part from the adapter for the bike cap.
Shipping. View from above.
View from below.
We try - the stability is good. So - everything is correctly soldered.
We clamp a drill in the cartridge - and shlude about the skin to shine.
Dremel cut the longitudinal grooves - more for beauty.
Spit again.
Dremel with a metal brush - and tedious work.
Ready.
We collect the top cover of the wick.
Basis - coin
Brass cap
Copper Wire Frash
Connecting bolt.
2 brass thick rings - to lengthen the design.
Fent button for composition
Before the spike.
In the cap drilling hole 4 mm.
In the coin, drilling a hole 2.5 mm - cut 3mm with switches.
Insert the bolt into the cap - we have done all the "beads" - and tighten the coin.
We apply a paste between "beads", and on the coin from the edge - we put the side.
View to spike - from above
soldering.
Side view after soldering. Well, garbage))
Grind the side. We clean from dirt. Dremel with a metal brush - and tedious work.
Dremel with a metal brush - and tedious work.
Sinterily .
Almost ready.
Everything is grinding to shine. This is the components of the lighters.
The latter before the wool packing is the installation of the chairs.
Insert the chairs in the "horns" - we do a brass twist twist through it 2.5 mm. - and neat blows of the hammer "sparing" one side, then a friend.
Not much - a little bit - this is enough that it would be reliably in place, and easily spinning.
Wool stuffing.
Before packing !!! - Put the wick, and only then fill with cotton.
I squeeze the middle - but whatever wick would be tightly grapted with cotton from all sides.
Collected.
It is good.
Gilt. Burning perfectly.
This flame will fall later - Fitil is fought.
Ready gift set.
Share
Video work.
Share - Magen Kening.
A source