Greetings to all needlewomen and sewing lovers! One of the important points when sewing the skirt is the skirt and lining connections. Many this raises questions. Now we will talk about how to sew lining to skirt.
In this case, I will consider the skirt without a belt, which the lining comes to the very top.
Starting lining and skirt on the upper cut does not represent difficulties, so I will not stop on this process. But how to sew the lining is a separate conversation to the skirt without a belt. I will show how the lining is connected with the skirt in the sewing place of the zipper.
Until a certain point, the vertical lining sections remain free!
Ideally, the upper slice of the lining should be punctured by phlizelin. I did not do this and give the Council on the basis of my practice. If you use a thin satin or a twist lining, then the fliesline will look at it not very well and in this case it is better to use the top of the furnace to which the lining fabric is then sewn.
And if you have a lining more natural, perhaps cotton, then Flizelin will keep well and does not deform it. Even for fixing the upper cut, you can apply a tape that does not stretch, and sew it to the allowance on the seam.
We fold the front sides of the skirt and lining and pick up the pins on the upper cut. Extreme vertical sections of lining and skirts are combined!
Returning from the edge of 4.5 cm, stepping around. On my fragment, I was only to its edges.
After that, we work with each half in turn. We turn off the zipper on the wrong side, as it will lie in a finite option, and leave the lining in the same position. We draw on the lightning line and translate it to the lining.
After that, we turn the lightning and connect both lines. Step from the side of the lining or from the side of the skirt. How it will be convenient for you.
The line reaches exactly the place to which the lightning is sewn.
At the top formed a free plot to be fed. We straighten it so that the zipa teeth be inside at the most bending and stepping this section to the edge.
Tailing lightning can be cut off. I do not cut angle. With a solid point, the angle will look more even. Soak and get this beautiful side.
The overall allowance must be fixed from the lining side by the line, reaching as close as possible to the zipper.
In the same way, we work with the second side, while the lining is still free.
After both sides of the lining and skirts are connected, we are engaged in lining.
We connect its vertical sections below the zipper and step up as shown in the photo. From the previous lines, we drop by 2-3 cm and move to the floor centimeter to the edge of the lining. Step up the edges of the lining to the bottom. We are triggered on the seam.
Here is such an exhaustion from me as a result. Everything is smooth and neat.
I hope that everything told it clear. If you need the need to perform this moment, then do everything in stages, following the photo instructions. Gradually, everything will be remembered and the question of how to sew a lining to the skirt you will no longer have.
A source