Watching in the internet on a variety of candle, fairy-tale houses, I really wanted myself the same miracle: -)))) So I decided to create, at the same time, the process pofotkal, so there will be something more similar to MK
In the meantime of view ... This is a view from the facade
The back of the building ... Stopping Cracing Skiding Specialless ...
Here are two end sides and pipe-pencks a little bit ... painting tried to do as close as possible to a natural clay, in the photo the color came out pale, well, with a color change on the pictures, I think everyone came across, in reality the color is in question, height 30 cm in width 17 to 20.
Well, on this photo you will not laugh at me very much, I really wanted to check the house with a twinkle inside and the little candle was not decent, I had to put such a fiery on a cropped plastic cup, get rich will buy a normal little candle in a round aluminum :-) ))
Well, now I'll show it all starting, a tin jar from the tea has long been Masolyel's eyes, and then the house I wanted ... In the size of the side walls of the jar, the jar painted the contour of the future walls of the house and the windows, on a rolled out of the test of the dough, the needle was cut off I have a stationery, a tin jar brutally crashed with a kitchen knife, I mean the windows and doors, so it's so uneven on a tin looks
This one of the prepared walls, after the night drying near the battery, she did not fully succeed, of course, but already at that shattering when I can already twist it and twist in my hands, missed the PVA glue, three remaining walls did the same
Militant prepared with carved windows, a hole that in the photo is glowing this line for the pipe, the wall put to the jar and pulled around the knitting wire, I have a first assistant, you can with a painting ribbon or scotch, well, in general, however, only the walls did not disengage on The photo is seen that there are gaps between the walls and the jar, well, so while I did the photo, then I tried to dock all the walls of the walls on all the seams and the corners. The pieces of dough put all the walls between themselves and the can And they have grown ...
Here are the extensive test layers throughout the perimeter of the house and on the roof, the pipe from the cardboard tube from the foil Cropped of course for the desired size, prepared and slightly dried box installed on the dough layer - floor, cut the floor to the size of the box and installed on the lubricated PVA gypsum fill
For the preparation of the roof used bamboo skeps, on the ends of the walls put a small dough sausages pressed the skewers, wrapped the PVA, the place where the pipe was installed were the big gaps between the skeins, the dough will fall, sickle sickles
Black roof roof
The roof decided to make the straw cut the test strips, made a fringe, laid the fringe on the roof of the strips
Here you can see a prepared roof and a pipe, everything seems to be clear the handset lasted the test, made a penneck
Penc is almost ready
Loskutka rags on the roof, the dough rushed on the grid of the sickle, acquired a square, put on the roof
At this, the main construction was ended after a little drying, a small work remained with the details, somewhere the stations, somewhere the steps, and so on, well, I already did as a hand fall, that is, it was adjusted for the resulting size and shape of the house, well, in general, everything…. If someone is useful, I will be glad ....
A source