It is completely easy to make a banquet. It turns out very practical and useful with a double function. On the one hand, the banquette will function as a bench, and if you turn it, you can use as a rack.
So, below is a step-by-step instruction that will help turn a simple rack in a very practical bench, which will also allow to store various items. In addition, you can add several wheels to furniture so that you can easily move the banquette.
From the rack in the banquette
To create the design of the seat, the plywood board will need, in this case, a thickness of 10 mm. After connecting different parts with glue and screws, you will need to be reconciled by a piece of foam rubber and upholstery. So, first put the rack, install the seat and, finally, put the wheels.
Instruments:
- Keyhole.
- Fabric for upholstery.
- Electric stapler.
- Screwdriver.
- Mounting brackets.
- Brush.
- Scissors.
- Tapestry hammer.
Materials:
- Rack.
- Plywood board.
- 100 mm foam.
- Leatherette.
- Double sided tape.
- Screws with a delay of 3.5 x 30 mm
- Screws with a delay of 3.5 x 16 mm.
- Staples 10 mm.
So, it's time to move to the creation of a banquette.
How to make a banquette: instruction
Step by step to make a bookplate.
You can start work with labeling and cutting pieces of foam rubber and fabrics that need to make the base of the seat. When performing this task, it is convenient to bind the board to the rack so that it does not move. Also advise using an aluminum profile or ruler. Thus, it will be easier to obtain the most ideal sections in a very simple way.
After five parts are cut, you need to apply glue on the joint area and assemble the design.
Pre-hold the angles using mounting brackets and strengthen the connections by inserting locking screws. To perform this work, you need to use a screwdriver with a suitable tip.
The turn of the foam rubber. First cut a piece in size using a jigsaw and a special blade for soft materials. Next, you need to fix the edge using the same tool. To make this work, you need to adjust the saw blade to 45º. And then, round a piece.
After the foam rubber is already cooked, you need to use glue to the base and glue a piece, well-centered, pressed so that it sticks out correctly. Then you need to tighten the fabric well and fix it forever. Remove excess material with scissors.
Following the same procedure, you need to use leatherette. In this case, it will be necessary to pay special attention to turns, as the final finish will depend on this. When crossing the fabric in this area will have to be folded artificial skin and, if necessary, cut the extra material.
Now you need to use wheels. It should be noted the attachment points and fasten them with the corresponding screws with a latch. Then put two conventional rear wheels, two front with brakes and one more in the center of the base, as amplification.
Finally, you need to put the seat on the shelf. In addition, you can store different things inside. Very practical and convenient.