I must immediately say that it will be a little harder than it looks like in the pictures. For the first experience, it is better to come up with a form simpler, especially if you do not have small handmade skills.
We need:
- Tin can from under cheese or pate
-Lineca
- Pencil
-knife
-scissors
-pliers
- Thread
-paper
For starters, invent the shape, draw sketches. As I already said above, it is better to take a form simpler. Perhaps the key will be complicated for someone. Then cut out our shape out of the paper. By the way, it is not necessary to do this at all, you can just leave the drawing on paper, but it was so more convenient for me :).
Then take a thread and marker. And outline the contour of our form, marker (points) all the sections of the bend on the thread. We are doing this in order to be easier to repeat the shape.
Now we take our tin can. I have this container from under Camumbert. It is important that the walls are rather thin and not too solid.
1) A large sharp knife make an incision at the top solid bark.
2) We insert the scissors into the resulting hole and begin to gently cut off along the border line. I used conventional scissors, they perfectly and easily cope with a thin metal.
3) We make a cross incision to the base of the bank.
4) And now cut through the bottom line.
5) So we cut out not too smooth metal strip.
6) With the help of a ruler and pencil, he evoke the uneven edge of our stripes, give it a rectangle look with smooth edges.
7) The same scissors cut up uneven edges on line.
8) And now still cut the strip into two parts along. We need a metal strip of a width of about 1.5 cm.
Now we can proceed to our form. In this case, the clavicle :)
1) Since the top of the key is rounded, then we need to find an item with a suitable diameter. It can be a handle or a marker. I have a test tube with sparkles)) we twist around this subject our metal strip and pressed your fingers to get a semicircle.
2) Then a pencil is transferred all tags from a strip of metal. So we outlined all the points of the fold.
3), 4), 5) Now with the help of a ruler and marker / handle / any item of a suitable diameter, we begin to gently bend the right form. It is very important to apply a ruler to the strip at a right angle so that the form is smooth. So, we apply a ruler to the point and Genne directly on the line. Here you can and need to help yourself with pliers and fingers to achieve the desired contour.
6) Well, the key is almost ready, it remains to close the ends.
To accurately connect the samples of the shape, you need to make a small smooth 2-3 mm width of 2-3 mm in such a way that they cling to each other. The picture below draws the principle. When the ends bent, we insert them into my friend and press the pliers tightly. Everything, the mold is ready!
And now run the oven beautiful cookies! :)) Of course, such a treat is better to decorate the icing, but I have been lazy)) But for the new year I will definitely be a stove cookies for all the rules - with icing and patterns :)
A source