This sunny flower is very simple in embroidery, but there are some nuances. Now I'll show everything! You can embroider both satin and silk ribbons. We take the hoop, the fabric, I - flax-scratched acrylic paints, a needle with a wide ear, scissors, lemon color tape 36 mm, yellow 25 mm and green shades of 10 mm, 16 mm, threads.
We take a lemon tape and representing where the Narcissus Center will enter the needle.
Returning about 5 cm, piercing the needle tape.
Each petal embroiders from the center and you need to "go" in a circle.
We flash all 6 petals. You can draw a circle to whom it is difficult for the first time.
Next, you need to take a 25 mm tape, a long 10 cm of dark yellow color, collect her on the needle, pull and sew in the center of the flower.
Stunned and sewn.
Now leaves. We enter the bottom of our tape and, retreating 10-15 cm, depending on the length of you need a sheet, piercing the needle so that the tip of the sheet becomes sharp.
The sheet can be beaten, but you can also leave straight.
Now stem. The ribbon must be fixed. You can make a node at the end, as you usually make on a thread. Thus, your stem will hold tightly.
Entered the tape from the flower and start to twist it. On again I will enter - it will be the end of the stem.
Narcissa has a ball on the stem. We put the bead and sew it.
That's what it turns out. The stem must be bent at right angles.
To the stem did not spin, you need to sew it.
This is an exhaust. It can be seen that I cut off every petal and leaf. Then you need to sew tips.
Insert the stamens in the needle and enter the flower center. And buds, I did not show how to embroider, but I will explain! We make a stitch tape, like a stitch thread, and a second stitch from above, it turns out a bulk bud
Embroidered picture of Narcissov ready! Enjoy your creativity!
A source