There is a whole bunch of complex master classes for the manufacture of such rings, but this is the simplest and basic, then what underlies this technique.
I saw that such rings made of brass wire sold for several thousand rubles. But why spend money when you can make a ring yourself, almost from the priest materials?)
We will need:
Wire (ordinary, brass or artistic)
Bead (Natural Stone or Large Beads)
Common pliers
Pliers with curved "beak" (optional)
Step 1: Cut the piece of wire long about 15-20 cm. Put on the wire bead, place it in the very center. For convenience, a special jewelry diameter is used to adjust the size. But you can take something round, coinciding in diameter with your finger. Wrap the wire around so that both ends look at different directions
Step 2: pulling the wire strong enough, wrap it around the beads 1 time.
Step 3: Repeat step 2, following each line of wire "lay down" below the previous one.
Step 4: And another circle.
Step 5: If you have already typed 4-5 layers around the beads, then you can proceed to the completion of the ring.
Step 6: Before finish the ring, cut off the excess wire (if any), leaving 1-1.5 cm from each end.
Step 7: Wrap the end of the wire around one side of the ring. Try to pull the wire stronger to get smooth loops.
Step 8: Repeat on the other hand, making 3-4 loops. Cut an extra wire so that it ended on the upper side of the rim (if you do it in the middle of the rim, then the ring can prick a finger)
Step 9: If you have pliers with a bent nose, then flatter the wire tip and press it to the rings as much as possible. In principle, this can be done with simple pliers, but will be somewhat more complicated.
Last Step: Gently Squeeze the loops with pliers so that they lay the tight towards each other.
Posted by: za_okean.
A source