In the age of computer technology it is impossible to imagine life without a computer or any other multimedia gadget. Those who understand the computers "hardware" themselves collect computers, giving them those or other characteristics that they need to perform the tasks. Some modify their computers, so to speak in your native shirt, and some go further, and make system blocks in a variety of variations. So the author decided to independently upgrade his system unit, giving him an exclusive, attractive and creative look.
For the base of the system, the author used a wooden rounded square. Such can be found in subwoofers. Naturally, they are longer, but if you have a tree or nozzle for a barrage, reduce its size to the desired it is not difficult for you.
The next step is to make a groove of the groove on the entire perimeter, in which the wall of the system unit will go. To do this, you will need a chisel and a hammer. If the farm has a cutter, then it will be even faster, and the result will be much better.
Next, at the top of the workpiece, we begin to cut with an electric jigsaw with an electric jigsaw for two fans. In the presence of more and the place can be installed and more. He will hurt. The place of the future drank places and on the border of the sleeve is placed either of the tape, or greyllic tape. This is not to be chips and sowing on the surface. A hole is drilled under the pink of the jigsaw and cut down. Insert the fans and look as they are located. If everything suits you, it's good. If not - I bring to mind - grind and so on. For further work it is necessary to remove them and postpone the time aside, because When carrying out other works, they will interfere with you.
Next, we are determined where and in which sequence you will have the rest of the connectors - USB, the place for the hard disk and so on. Everything is fixed in the same way described above.
It is installed one of the walls of the system unit.
Next, they make the installation of all components. Fasten everything on small tapping screws.
The metal wall is attached to the base and fixed. From the inside, the same is attached to the corners.
Now the hole is drilled in the wall under the power button.
We collect and secure the slats on which all connectors are located.
Next, make legs. They cut out of the same material that you use to build the housing. Glue them to the bottom and waiting for drying. For a more durable connection, you can drill through holes in the legs and non-pass through the housing. And all this is planted for a self-tapping screw.
Connect the power button and set the wall into place.
The author made the second wall from dark transparent plastic. On the perimeter placed LED ribbon. When you turn on the computer, it lights up and visible all the insides. It is quite beautiful and unusual. When you turn off the system unit has a strict look.
And that's what happened after the end of all works. In my opinion it is very interesting and unusual. I wish you good luck in the modification of your computers.
A source