In this article, consider three useful homemakes from PVC pipes. Namely a cutter for foam, hacksaw for metal and a stick for selfie. For the manufacture of these homemakes, the author needed the following tools: industrial hairdryer, spring bending spring, adhesive gun, drill, pipe shears, steel wire, vice.
Foam cutter.
For making a cutter, the author used the following materials: plastic pipe, nichrome wire, power supply, two bolts with a hook, plugs on the pipe, wires.
Cutting off the desired pipe length, the author of the self-made inserts inside her special spring for flexing pipes. That the spring could be easily pulled out, it brings the rope at its ends.
Then begins to heat the bend seat with a hair dryer.
Flex a heated place, giving the pipe the desired form.
Imprint cuts up. Spinning the hole at the bottom of the pipe encourages the wires in it. Stretches the black wire into one, and red to the other end of the pipe.
Drills in the plugs of the hole and inserts bolts into them.
The ends of the wires are screwed to the bolts, clamping the nut.
Inserts the plugs into the ends of the pipe.
For a homemade, the author used the power supply with adjustment. Dressed on the wire output of the power supply of a heat shrinking tube. Hispayl with wires cutter.
Shifting the heat shrink, warmed it with a hairdryer.
Processed the thermoclause the location of the wire in the pipe.
To give strength gluits a handle.
Between hooks, with tension, stretches nichrome wire.
All cutter is ready.
Since the power supply has an adjustment, increasing or reducing the voltage can be adjusted to heat the thread heating temperature.
Metal hacksaw.
For the manufacture of hacksaw, the following materials are needed: PVC pipe, canvas, steel wire, two spring washers.
Cuts a pipe in size. Inserts the spring, heats a hairdryer. Give the pipe to the letter S. The distance between the ends should be equal to the length of the hacksaw blade.
Whatever the hand slid, on the one hand makes a pen. From bending and to the end of the tube wounds on it steel wire.
Wire ends fixes in a stretched position.
When heated, the tube will try to take the original shape, so the ends of the tube author brought the tape with a tape.
Heats the tube with a hairdryer, pulling the wire at the same time. Thus, it makes the turns along the entire surface of the handle.
The ends of the hacksaw should be on the same level. Hangs them with scissors. At the ends in the middle makes the propuls.
Inserts a hacksaw blade into the cuts. In the hole in the canvas inserts spring washers.
Hood is ready.
Pick for selfie.
For the manufacture of a stick for selfie will be used: steel wire, plastic pipes of two diameters, plugs, clamp, bolt.
At first, the author does on the one hand PVC tube (larger diameter) turns with wire and hair dryer.
On the other hand makes four propil.
The smaller diameter tube should easily go inside greater, but not hang out in it. At one end, the hole drills the hole. Then heats the end with a hairdryer and gives it a flat shape.
The carving on the bolt should be the same as on the camera. Cutting off the ring from a smaller diameter tube, clothes it on a bolt hat. Bolt clamps into vice. The heating of the ring with a hairdryer gives him a shape of a lamb.
Bends a thin tube, at a distance of 8-10 cm from the flat end, at right angles. Insert a bolt in the hole.
Colors clamp black.
Dresses the clamp on the tube. Inserts a thin tube in thick and clamping a clamp. Applications of the chomut with a lamb will allow you to quickly change the length of the stick.
The adhesive gun is glittered with a glue and sticks it to the tube.
Sets the camera to another end and fixes it with a bolt.
Successful photos.
In more detail, the manufacturing process of homemade can be viewed on the video.
A source