If you have not yet mastered the technique of embroidery satin ribbons, then it's time to start doing this with this accessible and detailed master class. Look at the result. In my opinion he is great!
Embroidery tulips satin ribbons. Oksana master class
To start the embroidery of the "Tulips" pattern, we need:
Gabardin fabric or crea satin;
Green tape 6 mm wide - about 5 meters;
Green tape 15 mm wide - approximately 2 meters;
Ribbons multicolored 25 mm wide about 3 meters for all of our tulips.
Buy wooden frame
Buy needles with a sharp tip, (they are with a round tip) with different diameters of the ears. For different ribbons width.
Fresh cloth with ordinary stationery buttons. We stretch well. Figure Apply a piece of soap. There are disappearing markers, but I do not use them.
Tapes take on the wholesale database. In the shops of fittings, they are 5 times more expensive. Focusing in the size of the tapes. They are listed in millimeters.
The edge of the ribbon migrating a lighter and start to embroider. I pull the ribbon on yourself.
We enter the needle in the drawing, making the first petal from the bottom up. Tape not tighten, give volume. And immediately make a second stitch from top to bottom. We form a tulip of two petals.
After performing each flower, I cut the ribbon, causing a lighter edge, as if I would send a tape to the fabric.
To embroider the stalk, I take a tape with a width of 6 mm, bringing through the fabric to myself, twisting the tape into the harness and introduce into the fabric near the flower. I form a skeleton you need. If necessary, sewing gently threads from the inside to form the bending of the stem. Cutting off the inside, migrating.
Green leaves add arbitrarily, if necessary, fix threads.
To insert embroidery into the frame, cut the tablet of the desired size from dense cardboard, for example from packaging boxes. We stretch the fabric and fasten with the inside with threads, making the type of corset lacing) stitches are often done in moderation tight.
The back is pressed the same piece of cardboard so that our picture looks aesthetically not only from the face, but also from the inside. As a rule, the frame is sold with glass and plywood. The glass is deposited to the side (invent it is applied the next time), and we press our embroidery piece of plywood.
That new fixture has recently appeared. Hooray! This embroidery machine made me a husband for an hour of water pipes. I will not do the mind - how did I do without it before!? He makes it easier for me!
