Without a smartphone, it is impossible to imagine a modern person, but not everyone has a gadget stand. It is not always necessary, but when you need it - it can be done with my own hands.
It doesn't matter for what reason you needed a stand for a smartphone if there is no factory accessory, it is always possible to quickly make analogue of the remedies. Moreover, it is often not about disposable stands, but about those that can be used for a long time. ->
Stationery clamps
Stationery clips or binders will help to quickly and easily build a stand for a smartphone. It is enough to supplement them with any plastic or even a paper card, and the mount for the gadget is ready. You can build a more complex design of only binder - as you wish. ->
Paper or cardboard
If you remember the traditional Japanese art of origami or congratulate the scheme of the homemade stand from paper on the Internet, then the mount under the smartphone can be built literally with bare hands using one scissors and more or less tight paper or cardboard. ->
Wine plugs
If there are multiple wine plugs, a small amount of glue, a knife and free time, you can make a stand for a smartphone literally for a few minutes. There is a fairly stylish accessory. ->
Toilet paper sleeve
Cardboard sleeve from toilet paper A pair of knife movements turns into a completely wealthy stand for a smartphone. And if you add a more pair of plastic cups, then the portable column will turn out. ->
Stationery clips
If there are no binders clamps at hand, but there are at least a couple of large stationery clips, they will rise. A pair of movements can be turned into suitable to hold a support smartphone. ->
A plastic card
When the blood of the nose needs a stand, and at hand there is nothing but plastic cards, then they can be turned into a smartphone holder. It is better, of course, to do this, use unnecessary discount cards or at the thin end of gift certificates, and bank cards are left to the most extreme case, because after the improvement it is unlikely to use them in the main purpose. ->
Designer LEGO.
If there is a sufficient number of cubes and a rich imagination, it is easy to assemble a real multifunctional docking station. What is good - it is also easy to turn back to the designer. And this is perhaps the most universal way to create a stand for a smartphone with your own hands. ->
Case from audio cassette
Nowadays, it's easier to find the LEGO designer than the case from the audio cassette, but if it is at hand, then actually the stand is ready. Do not even refine anything - it's enough to remove the cassette and deploy its case for installing the smartphone. ->
Pencils and rubberbies
In the office, where many pencils and gum, but there is not a single stand for a smartphone, it can be made of what is. It will be necessary to simply tie a few pencils with rubber bands in the rack and make them together all the same rubber bands. ->
Roll Scotcha
Probably the most obvious and simple version of the gadget support for the gadget. It is enough just to open the smartphone to the roll of the tape or put the smartphone inside and release the hands. Do not even refine anything. ->
It is logical that 10 presented ways to create supports are not exhausted. The holder for the gadget can be almost everything that is at hand, if you show a fantasy. ->