Potion from the absence of a real ironing board? Prefer ironing without moving away from the dryer? To solve these problems, we have a solution. Today we will tell how to make a comfortable place for ironing where it should not be - on the surface of the washing or drying machine.
This simple fixture is attached on magnets, and when it is not used - it can be removed in a more suitable place.
Start standing from the choice of fabric. Suitable cotton or flax, preferably relevant. So that the tissue shrinkage does not occur in the process of use, comprehend at the maximum possible temperature, and then fade. The above-mentioned magnets look at the store materials for the hobby. For the inside, use a thin foam rubber, syntheps, and even better - felt. It retains his form much longer than two materials.
Tools and materials:
- cloth for the case (dense smooth cotton, flax);
- material for laying (felt, sintepon, thin foam);
- 8 small magnets;
- scissors;
- ruler and marker / pencil / chalk for fabric;
- needle for manual sewing and thread;
- Pins;
- Sewing machine and thread.
STEP 1
Observe the correct dimensions. So that your mat for ironing is firmly mounted through magnets to the metal sides of the washing machine, you need to carve out 3 identical parts with a size of 100x45 cm (2 of the fabric, and the third - from the soft material that you have chosen for the gasket). Also come out of the fabric 2 12x45 cm.
Step 2.
On the half of the fabric with the size of 12x45, place 4 magnets: at equal distances from each other. Next, fold the rectangle in half (leave magnets inside), secure the pins and take a needle with a thread. Do the same with the second part and remaining 4 magnets.
Step 3.
And now put parts with magnets to the wrong detail, leaving about 7-8 cm from each of the short sides.
Step 4.
Fold the details of the mat, as shown in the photo, and secure the pins.
Step 5.
Put around the perimeter, not forgetting about the turning hole.
Step 6.
Cut the corners so that when turned out there were no lumps.
Step 7.
And now carefully remove, join and squeeze the hole.
We are sure you did not think that it would be so easy?