Beautiful "dressing" for a sewing machine

Covers and mats for sewing machines. Ideas.

To do this, we need old jeans, a synthetic grade lining, small pieces of colored fabric for lining pocket and canvas with embroidery.

Patterns for Czech

First you need to build pattern details as in Figure 1. Start the construction is better with the sidewall (part 8,9,10,11).

To do this, it is necessary to measure the height of the sewing machine H, the width of the bottom x1 and the width at the level of the middle of the sewing machine X2.

Do not forget about the protruding details. They also need to be considered. And add to freedom of 0.5 cm on each side.

First build a simple rectangle with the H and X1 parameters. Find the middle of the segment x1 and swipe a dotted line dividing a rectangle into two halves. Then, on this line from top to bottom, reflect the segment equal to height from the middle of the flywheel to the top of the machine taking into account the protruding parts H1. After that, the circulation will build a circle with a radius equal to x2 / 2. Connect the bottom points of the rectangle with the circle and correct the upper half of the circle in the height of the rectangle from hand.

After the item is built, measure the length of the sidewall loop excluding the bottom. It will be the length of the part 1 (D).

Now we proceed to the construction of the detail 1.Thude everything is simple. The length of the sidewall d and the length of the sewing machine Y (do not forget about 0.5 cm for freedom) the first item is cut out of the synthetic gasket. After that, determine the middle of the rectangle and build a hole under the handle of the sewing machine without forgetting the allowance for freedom.

Next, make the pattern under the pocket instruction. Here, too, all construction consists of rectangles, to build which you only need to decide on the depth of pocket D1.

Everything else is calculated by the formulas below.

Now the details can be transferred to the fabric. I did it it turned out that the sidewalls I turned out of one pants, and the remaining details from the other. Previously jeans I resolve on lateral inner seam, and laid items so that the external seams look harmoniously. I was enough for my knee stuff.

Now proceed to the assembly.

First we fold the parts of the sidewalls from the synthet board and from jeans with an inside inside and spend a zigzag along the edge.

After that, we proceed to assembling the outer part of the pocket. Send to each other parts 3,4,5, where embroidery in the middle.

To the resulting detail to sew from above the detail 6. After that, stroke the seam, fold in half and make a decorative-fixing line.

For the details 2 to see the detail 7.

Do not forget to stroke the seam. For the resulting details, we apply the part 1 of the synthesis and sew them to each other in the center of the lines of the rectangular hole for the handle. To turn, turn out, try again and make a decorative and fixing line.

Now to the resulting detail you need to see pocket.

At the request of the rear, you can see an overhead jeans pocket.

The most complex process of connecting lateral parts with the main one remains. It is practically like a sleeve to sew. Do not be lazy to first be aligned, turn out and see how it will work out and only to take off.

At the very end, I wrapped the edges at the bottom inside and shot. Everything is your clothes ready.