How I washed the bed
I wanted me and my beloved means to get a bed, looking at prices and quality in stores and a bit of progresses, it was decided to make a place for a sphanish and merry. I bought everything you need, it started. I removed everything to the screwdriver, so the quality is appropriate. From the board 130x30 mm. made a rectangle for the size of the mattress, in the ends screwed up 2 screws and reinforced with metal corners
Next of the 40x40 mm bars. made the basis for a crate for the mattress
Bruck cut 20x40 mm. Here, a bit of accomplished at first, the barbers placed very rarely, then it turned out that the mattress begins between them, in the consequence corrected
Fitting the mattress and testing the overall, approved, can be done further
The legs made from the same bar 40x40 mm. 4 legs in the corners and 2 in the middle so that the lamp does not burn
Again fitting and getting approval from bosses
To give an aesthetic species, the bed decided to cover with white dermantine, or as it is correctly called there, with a lining from a foam rubber 10 mm. Unfortunately, there are no pictures of the tightness itself, there is only a foam rubber
The headboard did from the OSB, because it was in me in the presence, stated under the openings for buttons
Drilling holes in OSB, and covered with his dermantine with a foam-rone of 30 mm., Attached the headboard to the frame on the self-tapping screw
Further fucked in the headboard buttons, pre-trimmed with the same material as the bed, the strong ropes are tied to buttons, stretched and fixed on the reverse side by self-draws
The final appearance of the rigged product
A couple of weeks later, wool made adjustments to the appearance of the bed, right in the photo noticeably
The bed turned out to be good, but during intensive operation, characteristic screensions appear, it was necessary to lay all the joints of the bores in some material. Budget: Mattress - 6 tr., Trucks 3 tr., Selfless and corners somewhere 300 r., Cognac - 500 p.
I'm all cumshot
a source