Long walked with your wife in search of a crib, but all some kind of nonsense has come across. And if there were beautiful cots, then their price was cosmic. In general, I was psychulin and decided to make a crib myself. Since I am an architect by profession, therefore there were no problems with drawings and calculations. But the sketch made it possible to make his wife. Since the main customer wanted a bed like a princess, his wife drew a bed with a canopy.
But the difficulty was that the bed was planned to do from LDSP, and the racks for the Baldakhin would have to do the same from the LDSP or from the chrome pipe. I did not like these options. Baldahin I will make a separate forged element, but I have not yet invented how it will look. How I will post.
The size of the bed was chosen under the mattress with dimensions of 800x1900mm, because Parents will sleep to sleep and do not sit on the floor))). Therefore, the crib turned into a grow.
By the way, about 5.0-5.5 tr. + Mattress 4,5 tr.
After determining the size of the crib and clarifying all the wishes, I took a sketch and sat down for the drawings. Who is interested, lay out drawings with sizes at the end of the post.
Cut and the milling board ordered where he bought a lemp. Drinking meter sawed - 9 r. / Mp. Milling 6 parts about 750 p.
The edge glued himself. Since I do not have a construction dryer, I had to take a tool of my wife.
Laugh is not worth the iron gluits perfectly. The usual stationery blade is cut off excess edges.
After the edge is pasted, you can start assembling
The process of markup and drilling holes did not photograph. I think everything is clear.
Well, the backs and ready
We proceed to assembling the rest of the parts
Since I suggested that this is not only a bed, but also a trampoline, I decided to enhance the corners.
Well, the frame is assembled, now we turn to the drawers. The bottom of the boxes did not do from the fiberboard, but from LDSP, because They are quite large and you can load them in full.
Collected, collected and the hand shook ....
It is good that there was a spare drill. After assembling the boxes, we make fitting and secure guides. Guides took good, withstanding the load up to 50kg.
And while the bed is turned turning the heels
We try again and check how boxes open.
We try on the facades on the boxes.
The facades turned out with a decent gap, because When cutting facades made 5mm less. Honestly, the cut did a terrible. All sizes walked from 2 to 5 mm. But this is noticeable only on the facades of the boxes. After fitting the facade of glue and immediately screw the handles.
During the screws of the handles, the chief specialist of the technical control department was coming)))).
Well, check on the strength of the boxes.
After approval of the main one. Controls are placed on top of a sheet of LDSP and mattress.
Here is the result of work
As I assumed this and a bed and trampoline. I asked to stop to take a picture.
Who is interested in posting drawings and material consumption
LDSP (1830x2620) - 2 sheets of LDSP + 2 parts №13
Edge - about 45 meters
Shkant - 16 pcs
Confirmate (Evrovint) - about 45 pcs
Roller guides - 2 pairs
Metadic Corner - 4 pcs
Self-tapping screw 18x3,5 - about 50 pcs
Screws - 32 pcs
Furniture handles - 4 pcs
Heels - 10 pieces
To do not get confused all the details in the drawings divided by colors.
Ringing diagram Ledsp
a source