How to make a stool in a couple of hours.
Kirdyk stool
Small broke his stool and I decided to make him strong - wooden.
Littered on barn and scarked by Soussekam. Specially did not buy anything, everything was found in the honeycomb, only the waders did not have enough, it was necessary to cut the knife with a knife from the board.
I found a bit of a lump 25x25 (legs) and rails 20x40 (upper strapping), 20x30 (lower strapping), for the seating took cropping euro lining.
For fasteners, 8 euro screws are needed (confirmation) and 16 wooden wickers of 8 mm, 4 small corners, screws 3.5x20, 3.5x40 and joiner glue. From the instrument you will need a saw, drill, drills for 5 and 8 mm, jigsaw, roulette, pencil.
Sawn details
First of all, mark and cut all the details in the size you need. I will not specify exact sizes, as depending on the size of the materials available, they will change.
Through holes on the outside legs
Next, place and drill holes on the legs. The upper strapping is performed on 1 euro screw and 1 dust on each side. For this, on 2 adjacent edges, we place 2 holes, and on the one side the upper will be through, and the bottom is deaf, and on the second grain, on the contrary. It is a deaf and through a hole that we carry out the drill on 8mm.
Through and deaf holes on the inside
Top fastener
That's how it should happen
Go to the holes for the bottom strapping. There are all simple, we only make the deaf holes for the wadder, it will be quite enough.
The legs are ready, now add the holes on the details of the strapping. On the upper strapping, we make one hole of 8mm under the wanking and one 5 mm under the euro screw, while do not confuse the opening of the opening 5 and 8mm, they must be opposite each other and not diagonally. On the lower strapping, the reeling 8mm under the wanking.
We collect the frame, without sorry the glue on the dust connections.
With the assembly, I think questions will not arise
Curly corners
For the manufacture of seats we take the required number of boards, write in size. Extreme boards dissolve along to remove the tongs. From the bottom side we connect the rails on the self-drawing. Corners twigrating the jigsaw, after placing some round jar.
We connect two slats
Fresh corner
Krepim sitting to the frame in small corners.
The customer remained satisfied!
A source