How to make a bench with a back Simple and cheap in the manufacture. It has long been looking for such a design bench with a back and that it was comfortable.
I found and offering the test version to you. The time of making this bench with the back for a few hours will start?
The design is somewhat old, but we make a bench for recreation in the country or in nature and what is required of it except the fortress convenience in ease of manufacture?
Here is a scheme bench with back :
In order to make a bench, you will need a board long six meters of 190 x 19 mm or trimming of which you can cut it out. The board must be put in front of the cutting. It is not necessary to process it, if you only plan to cover it with a mourn or antiseptic, but it is better to do it later. A few more stainless screws are needed - galvanized suitable just.
As already spoke on the manufacture of a bench takes several hours, let's make it:
one. Customize under 22.5 º Delusa Circular machine, saw or simply draw from hand pattern. It is such an angle that is needed when cutting out the legs for a bench, so that the backrest is comfortable. The long six-meter board will have to cut five times to get four legs. Two short rear 440 x 190 x 19 and two long front 915 x 190 x 19.
2. We fold the front and rear leg So that the short was inside the bench. The same repeat with two others, but in the mirror reflection.
Align , We check that both pairs of legs are symmetrical, (you can put on each other) further clamp the clamps
Fresh legs. If we are fixed on screws, you chose the holes of a smaller diameter (than screws) in the front legs and we make a flush drill under the helm flush. An even smaller holes drill in the rear legs. This is done in order not to split the board when screed. Then we tighten the legs of the bench with 30 millimeter screws.
You can make this fastening and on ordinary galvanized bolts and nuts - if you do not trust screws.
For special reliability, you can add wooden hoptes and put the legs on the glue.
3. I exhibit the collected legs In parallel to each other, the front legs on one line, short legs orient back and inside the bench.
Finishing the seat From the dual board with screws by 65 mm, also stainless.
Fresh back Benches are the same screws.
four. Go to the finish. Painting or process a bench is needed anyway. It is located outdoors and it needs to be protected from precipitation. It is possible to cover it with ordinary oil paint for facade works, you can handle an antiseptic with a kel - options for weight ...
I will give again all the sizes of the bench bench:
- Rear legs440 x 190 x 19 2 pcs.
- Front legs915 x 190 x 19 2 pcs.
- Seat1112 x 190 x 19 2 boards
- back 1150 x 190 x 19 one
I hope and I explained everything clearly, and now you know how to make a bench with a back for all 100. Good luck!
A source