I decided to prove to prove that I could (the author says), I remembered the autocadus from the uni, draws everything that you need to cut down, I went to StroySuvenmarket, I ordered polished and fiberboard for a liner. The bed decided to do with wide former under the mattress 180 * 200cm, to put on them any book or mobile.
Project budget (in USD not to suffer with a course):
Chipboard 64 $, corners and attachments 28 $, lamellas (platbands, pine) $ 34, leatherette 53 $, foam rubber $ 36, 38 $ lifting mechanism (for 1200n - too much came out). Total bed 267 Well, the mattress is $ 146.
Hisp brought and disassembled the old sofa.
Put the back side and trying on the board.
Fasten to corners, and after and on confirmates.
Collect the framework.
Top cover I check the correctness + kote leads quality control.
Glass of red, drawing and control.
Top covers check rectangle.
I threw the mattress and realized that the gaps were too big between the mattress and the frame, I did it intends, because the foam rubber and leatherette will be added.
Collect the frame under the mattress.
Fasten to corners and confirm.
I stabbed the corners of the crossing under 45` - the car helped me very much and also helped during the construction of the staircase at the cottage - I will paint the report.
Confirmates.
Pretending.
The central bar serves as a support for the mattress frame.
Raised the whole design on the chairs that it would be possible to work not on all fours and hide the edge of the leathesum below. He lifted himself in a circle I put the book (as not regrettable) Already to the height of the chair.
The file is dulling.
It is
Set .
Tight carcass.
Porolon on a frame of 20mm on the end 50mm.
I estimated the frame and I realized that it was not included because of the fact that there was a 50mm foam rubber, this is despite the fact that I made a stock of 4 cm and a frame less than a 4 cm mattress.
He again removed the trim, sliced the foam rubber, he won on himself and collected again.
The frame stood perfectly in every sense, put the lifting mechanism.
I figured the mattress - the baille in the baille fit in the opening. Focused fiberboard Box for linen - lying under the bed.
I lowered on the floor with help again books.
In work. Box for linen is huge.
A source