TV antenna from beer cans

Anonim

Very often there is a situation where the regular television antenna does not take broadcast channels. It can happen on a picnic, in the country, in a rural manor. And in the urban apartment, especially in old houses, the reception is not always ideal due to the mismatch of the load and the general antenna in the house.

TV antenna from beer cans

Meanwhile, even the most lazy and nothing in the technique of a person can in 10 minutes, literally from garbage, make a real TV antenna, the quality of which is comparable to industrial samples. It happens that it works even better than the purchase - catches more channels and provides a higher quality picture. This is all the more surprising that the antenna consists of only ... empty beer cans.

Tools and materials:

• Two empty beer banks

• Scotch or tape

• Two screw screws

• Antenna cable

• plug

• Stick

• Screwdriver

Step 1

Banks are primed up to a stick with scotch tape or tape.

TV antenna from beer cans

Step 2.

Self-tapping screws are screwed into the banks, and the ends of the cable are cleaned and fastened to self-drawing.

TV antenna from beer cans

Step 3.

Scotch tape cable or tape for strength is tied to a stick.

Antenna is ready!

You can use a wooden hanger instead of a stick, then the antenna can be suspended somewhere.

TV antenna from beer cans

For high-quality reception, the distance between the banks is desirable to choose experimentally, but on average it is about 70 mm.

If the launchers are not separated from the cans, the antenna cable can be attached directly to them with a screw and nut with a washer.

When installing an antenna on the street, it will be exposed to various atmospheric factors such as rain, snow, wind, etc. In this case, to give stiffness and tightness of the whole design, both banks can be placed in a large plastic bottle of beer, pre-slicing from her donyshko and neck. For cable in the middle of the received cylinder, it is necessary to pierce the hole, which after the connection you need to scream with hot water. Plastic bottle is deformed and sealing a hole.

It should be noted that the space for creativity in the field of amateur antenstrianization is almost unlimited. Proof of this is the photos below.

TV antenna from beer cans

Advanced antenna with several sections

TV antenna from beer cans

This is a long-known design, was still made of canned-dryer canned cans.

TV antenna from beer cans

Perhaps banks from under different varieties of beer take a signal differently. We offer readers to find out this question yourself, after adjusting the contents of the cans (joke, of course)! Pleasant creativity!

a source

Read more