In the head "Spikes and Roses", tin is associated with sharp spikes.
Therefore, you need to perform work very carefully, take care of your hands.
For the manufacture of roses from the cans, we will need:
- Five canned cans from under PATTET (including 2 covers from them);
- Hot glue (thermopystylene);
- Scissors are simple and zigzag;
- Acrylic paint;
- Brush;
- Round-rolls (if necessary) or tweezers;
- Foil.
We take tin cans from the patenta and cut the extreme rim. Sliced bezel do not throw out, it may later come in handy.
The side of the bank is cut into six equal parts. Split corners of each petal.
The edges of each petal bend, giving it a kind of naturalness, if necessary, use the round-rolls.
Making a rose core
Take a piece of foil and smile to her, form a ball.
Fingers make petals concave. In the center of the resulting flower, we glue the ball from the foil.
We apply hot glue to the lower part of one of the petals and glue it to the ball from the foil, as if covering it, pressing the petal to the ball on all sides.
Similarly, we glue the second petal from the glued one to the ball, that is, skipping one petal.
And again, skipping one petal sticking the next one.
After this, we glue the remaining petals one by one, thus, forming the core of the future rose.
Now we take the prepared, already described, the second canning can and in the center it is glitched by the core of roses.
note that gluing the core need to be positioned so that the boundaries of the petals are in the center of the petals of the second rose layer.
Also, as in the first layer of roses, we first glit to the core of the petals through one and then all the rest.
Similarly, glue the third, fourth and fifth layer.
Making leaves of roses
For the manufacture of leaves, we take the covers from our canning cans.
Begin the cover in half.
Zigzag scissors cut out a leaf.
We put the workpiece into the harmonica.
Deploy the workpiece and get a leaf. There should be two of these leaves.
We glue leaves to rose.
This could be stopped, but you can go on
Making a rose mustache
Take the rim cut off from tin cans and screw it on the handles of tassels or pencil.
We glue the resulting curls between the leaves.
You can leave in this color, and you can repaint just made with a rose to the desired color using acrylic paint.
a source