You will need:
plastic cans from under the cream;
Ponocent, dense foam or thick foam polyethylene;
knitted decorative fabric (velor, velvet);
soft skin;
Glue PVA "Moment" .1-2.
Of the foam, dense foam or thick foamed polyethylene (it is used as a packaging of household appliances) cut the circle on the diameter of the jar. On it with a ballpoint handle, draw a few parallel lines (after 2 cm), which will serve delimiters for decorations. Now insert the circle into the bank and make a thin knife along the lines of cuts, not reaching several millimeters to the bottom.
3. From soft velor or velvet fabric, cut a rectangle with a length of 2 times larger than the diameter of the box and 4 cm wide larger than the diameter.
4. Fabric from one narrow edge Show between the casket wall and the liner.
5-6. Then, with the help of a flat tool, shove the fabric to the bottom in each incision, holding it with one (stretched) side and pulls up a free end all the time.
7-8. Fill in the cloth all the cuts, also shove all excess fabrics on the sides. Now in the separators will conveniently hold on crews or rings.
9-10. For the sacking of the jars, cut the skin strip the length of which is equal to the girth, and the width is equal to the height of the side wall (without a twist) + 1 cm on the bending. At first glue the strip on the side side, and then wrap the allowance of the donyshko, evenly distributing the folds.
11. Clamp the skin of the appropriate diameter with donyshko and allowance.
12-13. For the covers of the cover, cut the skin strip, the length of which is equal to the girth, and the width is equal to the height of the cover + 1 cm on the bending. Cover are caught the same as the side walls, wrapped the allowance to the top.
13-14. Then cut the circle from the soft leather at 1.5 - 2 times larger than the diameter of the lid. The cover is abundantly lining the PVA glue and distribute it to the allowance. Then attach a leather circle: first in the center, and then gradually shifting the edges of the circle to the level of the lid edge. At the same time, forming large folds in the middle.
15. To the fingers evenly distribute the skin along the edge, forming small corrugated folds.
16. Now evenly push the large folds in the center, forming a small relief. When everything is satisfied, add all the reliefs, pressing them with your palm. Then walk the finger over all the small folds along the edge in the direction from the center outside, smoothing the cut. If necessary, you can slightly add glue.
17-19. The seam on the lid can be closed with a leaf, and on the side wall - a bow. Therefore, gluing the composition of the flower and the casket is ready.
20. Using this method, you can make an organizer from any dense box of suitable size.
A source