Many of us are tired of the monotony of iron machines, for frequent their appearance is nothing wrong, and it looks like an ordinary rectangular box. One of the foreign fans of modding is better known as Fychan provides us with one of its projects, which we will try to repeat. The entire creation process will be described in detail, and is shown in existing photos.
Let's start with the fact that we will analyze the home personal computer to the components of the part.
Next, take the future building, as you already, probably, we understand, as it will use the usual mannequin. We begin to cut it in half, as shown in the photo, we use the most convenient cutting tool for you. Ultimately two separate halves should be released. The sharp edge is cleaned by emery paper in order not to be hurt. For the power button, we make a hole from the neck.
The switching on the network will be located at the bottom of the foot, for it we also make a hole.
Then take the motherboard, it must be prepared a little, take a small sheet of a wooden panel and cut the square from it, take dimensions according to the size of the motherboard. Next, drills the holes, and the fertilization fee to the carved panel with the help of hexagon brass racks. Drain foundation in the future install in the case, it is in order to simplify the mount mat. fees.
We begin to try the insides, we look at where you can accommodate. When they were determined with the location of the parts, we begin to fix them, we use metal plates, or any other convenient existing fasteners. For clarity, we look at the photo report.
In order for the system does not overheat, you need to add cooling.
At the top of the neck we make a hole according to the sizes of the cooler, it should go there a little with an effort. When everything is ready secure on the available fasteners.
Since the factory mannequin has a not quite visible look, we produce painting work, ground, then we apply black paint. Before painting, do not forget to dismantle the entire electronic part. When the paint gets up, for a better effect, we apply a layer of glossy varnish.
Further, when the housing is finally driving, mount the entire filling back, then connect two halves with each other. As decoration and fixing element, use a metallized swimsuit.
Work can be considered finished!
We put an updated computer case to the workplace, and look at the surprised faces of acquaintances, attention and subsequent questions are provided to you.
A source