How my wife and I washed a chair (nanopost)
We decided to make chairs for the cottage. Found in the Internet the drawings and proceeded to work. I will immediately say - the bar 35x35 is absolutely not a running size, therefore they took 40x40. We will need one chairs of 5 bars 3m each, 4 M6 studs 1 meter and nuts with washers.
Began to saw and post all parts for drilling. Both are attentive - Idiotic marking, but accuracy is important.
I walked the set and the edges was processed by a grinder with a petal disk. Locker 80. At the same time, the wife was whining the bars and brought them to mind using a orbit with a 120 skirt.
It is time of test assembly. Assembled, they understood the nuances (in the manual it is written that it is necessary to drill F7 drilling under the heel, and I drilled F6.5). Believe the instructions :). After that, the chair was disassembled and went into painting. Beautiful wife :).
After painting again collected and it turned out like this. The chair is convenient and comfortable.
It develops and does not take up much space.
Thank you all for your attention, I hope it is useful.
A source