I will start at first: I needed a string (again the same as the first slippers). Their advantages are in strength (the thread is a silk), the color is not brand and at the same time with a shiny thread. A piece of linoleum for soles. You can use a rubber rug or sole from old slippers. And ... plastic bottle, more precisely two strips from her 1.5 cm wide and 15 cm long hole punch holes in the middle of the stripes and spin the corner scissors. The sole is tied up, pre-punctures hole holes. Also we bind the stripes, while connecting them together at an angle of 90 gr. We connect both details together by putting the whole sole with a strip of a rachy step. We proceed to the manufacture of the "holder" of the upper and lower parts of the slippers. To do this, I traveled through the bead thread, from her tied a chain of air loops and trained it through a piece from the dropper. You can also leave a chain of air loops, and you can drive beads. But you need to look so that it does not hurt between your fingers. In the sole, between the first and second fingers pierce the hole with a seboard and fix our "holder". I fasted this way in this way: tied with both sides and was still wrapped with glue. The most pleasant and at the same time is the most painful stage - the decoration. I was decorated with just beads. From the wrong side, I stuck out the soles from the old slap at the calculation, which I would wear them in the summer on the street. I wish your feet comfort and comfort!
A source