Plywood will need, the cans themselves and a little perseverance. Brilliant and simple design that will help save a lot of time.
What do you need
The sheet of plywood (thickness is 10-15 mm).
12 cans of the same size (800-1000 ml)
Medium-sized screws
Screwdriver and screwdriver
Tree simulator (dark)
Lobzik
Pencil
Rule
Marking
Before making a hive, prepare the necessary tools. We take a sheet of plywood. Pencil note 12 points at an equal distance. From each edge, we retreat 10 cm. You should get the same markup as in the figure. Points may be greater or less (depends on the diameter of cans).
Lobzik and cut round holes in the lines crossing places. Banks must be tightly inserted into them.
On the perimeter of plywood, fasten the frame from the slats.
It is also necessary to strengthen the beehive planets from the inside to ensure that the design does not seem under the weight of the honey.
The box of the hive is at the bottom. Fake frames for honeycombs. Next, cover the design with a sheet with holes for cans. We do not forget to put a special lattice so that the uterus one of the cans does not "nubble" by the larvae.
Open the design by the mourn and mount the jars.
Beehive is ready! And if you still put ready-made honeycomb into the new house, the bees will postpone the honey right into the banks.
A source