Igor Rudavsky's lamp from D. Kuritichi Gomel region. Collected from what was at hand. On old cast iron stirred symmetric lines and points. Inhatever the holes inserted the holes of different diameters, and on the lines made pegs with a grinder. In the bottom he drove a few holes - for fastening with self-drawing to the oak plate, as well as under the ceramic lamp cartridge - it is not afraid of high temperatures (if the lamps are energy-saving, then the plastic cartridge can be used).
A piece of oak hollow covered with a tree impregnation. The chain and cast-iron painted the heat-resistant nitroemal from the canister: the chain is silver, and red stripes added to the cast-iron.
Then I collected the product: the cartridge with the wire screwed to the cast iron, and that by the screws to the cry, stretching the wire through pre-drilled through channels.
From a couple of pieces of chains, he made a mini-rocker on the ceiling, hiding them on hoozy. The finished lamp in the ends invested in these loops - ready! Electricity can be connected.
By the way
Cour from the rusties can not be removed - it looks colorful. Instead of impregnation, lacquer or verse is suitable.
On a note
You can drill cast iron by conventional metal drills, not allowing their overheating and blackened - interruptions should be taken or cooling with water.
Holes first better do the drill with a small diameter and only then large.
Fedor Krasnopolsky. Photo by the author
A source