At the request of interested - I post in stages.
So, the step is the first: from the profile I make a frame for a sample, who will sculpt on the wall - to that, naturally, without need
The next step is to screw the plasterboard to the frame, self-drawing. I decided to make a "corner", for clarity. Then the putty on the gypsum-o-one layer - and to be primed.
The residue of the drying putty was put on the chip of plaster, then let's see, may come in handy ...
I stick a piece of drywall in the size of the future brick, I begin to puck a putty ("fugenfuller"). Plasterboard is simply for a set of mass so that there is less spacing.
Namazyukal - a bit dirty - and let's show it on what the light stands!
I looked at the result - I think: you need to try different techniques. Started again:
By the way: Another technology is different on the lower bar: the spatula "on the separation" - a little grabbed and to burn, but without a fanatosis!
As a result, we have this:
Slashing "seams" between stones:
Pain with wax mastic
I am dragging when marships will grab a little, we have this:
Lepota!
On the wave of enthusiasm, they scat from putty, at least to fill empty places:
Euphoria does not pop up- so that they flew on the future for the same:
We are leaving for two steps, we admire the result, knock themselves the heel in the chest - hooray! It does not work with wax, it is still raw, tomorrow I will smell.
By the way, remember about the sticking putty? By tosing a bit of her spatula we get some kind of garbage, covering garbage mastic - God with her, let it be:
Here.
Materials: Figuefuller's universal putty, water, nerves.
Tools: Hands, Two Spatula, Rapid Knife.
Good luck to you, gentlemen!
A source