Citize the author!
I can not exactly name the type of creativity of what happened from ordinary fabric. Namely - it was necessary to work with the tree of happiness to apply some unusual pot. Under hand, as always, nothing has happened, and with a light heart, it took to build it out of matter, very comfortable material when there is nothing. I have no doubt that many use this technique, but I hope that the reminder of this method to build a similar one will come in handy, and someone will just be interested. Sorry for the quality of the photo. The work was done when the homemade will all hurt, respectively, the picture in the dark.
Materials:
1. Fabric, better dense 50 * 50 cm, depends on what size the pot is needed. The color is better to immediately choose under the tone of the future pot. Less it will be necessary to paint.
2. Empty capacity - a figured bulk bottle, I had from under sunflower oil.
3. PVA glue, water
4. Acrylic paints, brush
5. Threads, needle, any rope
6. Newspapers, plastic bag
7. Bow for glue
8. Acrylic lacquer
We try the size of matter - to the center of the matter, we put our capacitance-boobbin, cut the circle and weathered the cloth edges of approximately 4-5 cm.
In the bowl, pour glue plow so that our whole fabric rushes, we dilute with water (the less water, the stronger the product will eventually
Well wet our fabric workpiece, you need to remember it from all sides, squeeze it several times and wet again.
We press the slightly, lay out on the table (bottom bottom) and straighten.
In the center of the tissue, we put our container, pre-wrapped it into a plastic bag so that it is easier to take it out. As a note: the workpiece can be taken and a simple smooth jar or a bottle, to wind the crumpled newspapers on it, fix them with scotch and further use as a curly bottle.
We begin to form a pot, raise the edges of the fabric, laying folds. The edge of the fold should be in the very narrow invading eye place. Fix the rope. Once again we form all the folds as we wish.
In this form, leave to dry, you can close with a battery or hairdryer. I have almost a day.
Everything dried, the fabric grabbed, became like a stone. Now you can paint the blank without removing from the bottle in any color, this is the first layer. At each stage of staining, add a PVA glue into the paint, it will further strengthen the product.
When again everything dries and the fabric will become even more like a stone, you can pull out a bottle. We remove the rope and, without spoolding something to spoil, push the fold with the force with the stream and get the bottle.
Now you can give the paint everywhere where it remains not scratched, and then paint the main tone. The folds that we have formed, have no luck anywhere. You need to cry everywhere well, and you can not touch inside. Again everything should dry well.
At this stage, if necessary, you need to fill the intraity of the pot (plaster or foam or what other filler) in this work I cut off the lower part of the bottle, filled it with plaster and fixed the trunk of the tree in it. When plaster froze - everything loaded the pot inside.
Fix a tight rope of the neck of the Gorge, leaving the neck. And necessarily clisp of 2-3 times. And then decorate at your request.
I applied my pot for the happiness tree. The customer was satisfied and did not immediately realize from what he was built.
Here is the result
Thanks for attention. It turned out to be very interesting to work on a master class. Sorry if damn komom.
a source