Jewelry ABC - how to make spirals from wire and an example of their use

To work, you will need: wire - 1m. Or you can take from the cable, the truth will have to be tinted with a braid.

Buds, round-rolls, cliffs, pliers with protection, or smooth area, accessories (Schwenza and Pina), beads.

So we bite the piece of wire about 20 cm long.

We do at the end of the loop.

Doogibeze to get a smooth circle (approximately)

We take our pliers with protection and begin to twist the spiral. I will show two types of spirals, in the form of a connector, with a distance between the turns and a dense in the form of suspension. In this embodiment, the turns lie loosely. Pliers clamp a spiral with a plafferous hand, big and index finger of left gym wire along the coil

Approximately see 6 to the end of the wire (depending on the size of the spiral), we make a corner (then suspend the bead then). For this, round-rolls or water climb the wire by putting them perpendicular to the edge of the spiral, free hand with a flexible end of the wire still on a wool

It remains to make a loop for fastening the Swedza

For strength, you can beat off the wire

Now the second version of the spiral - suspension. We also start - the round-rolls bend the tip, a guy to the circumference, and then in a thumb tightly, our wire in the course of the spiral

Leave a small tip for the loop (about 1 cm)

and bend the root hinkee

Now we make the mount for the beads. To do this, you can take ready-made PIN in the store of fittings or make it yourself and wire with a diameter of 0.6-0.8 mm

We insert the PIN into the bead (I added small cups for beads for beauty) and bend the tip for 90 degrees. For the loop, we leave 0.7-0.8 cm, too much we are reworked. We are bracking the rounds of the loop.

Now we connect everything together. Impretten loop at beads

Connect the spiral with the loop

Similarly, attach Schwenza

Serge is ready) It remains a couple. Option with connector. I took a bead in the form of a drop. Mounting to her is done like this: we take a piece of wire with a diameter of 0.6-0.8 mm, bend the tip, insert into the bead, we bite up too much, bend the second end of the wire and bending the loop

We attach to the connotor spiral, connect with Schwenza, ready!

Here is my use of a spiral

A source