Sandblasting is hardly the best and effective way to remove rust or paint. True, such devices have one serious drawback. It is in the sand flying in all sides. This forces the owners later make tremendous efforts to clean up, as well as use protective equipment. The design of the sandblasting machine can be modified using an unnecessary door from the washing machine to forget the most part of the inconvenience listed above.
What will take: Door from washing machine, purge gun, plastic bucket, welding glove, plastic cans
We take a large plastic bucket and cut off from it with the help of a suitable tool to the upper part so as to completely remove the eyes and the handle. Next, the door of the washing machine is taken and stacked in such a way that the glass lay down in bulk. Self-rims are screwed to the door rim, which is satisfied with the half of the door frame from the washing machine.
Next, take the tube of the blowing gun and we make a thin cut in it, through which the sand will arrive. We take the plastic bank and make two holes in it at the bottom opposite each other. In one of them is introduced and the spout of the gun is fixed. Then at the top of the cut earlier bucket makes a large hole under the just cooked bank.
A plastic bank is inserted into the welder's glove without the bottom, after which the glove is welded in any available way in the hole done earlier in the bucket. Opposite the gloves, on the other hand, a slot is made to enter the spout of the purge tool. As soon as the gun picks sand after launch, the bank should be covered with a lid - the door from the washing machine. Thanks to her, the sand during operation will not crumble and it can be reused.
Video:
