There is little pleasant if you have condensate in your bathroom or toilet on the pipes. Firstly, the water accumulates on the floor and has to be removed from time to time, secondly, due to condensate, the life of pipes is reduced. Condensate contributes to the formation of mold, which can lead to allergic diseases, and finally - the condensate on the pipes is simply not aesthetically. The reasons for the appearance of condensate on the surface of the pipes are several. Before deciding how to get rid of condensate on pipes, it is necessary to find out the causes of its occurrence.
Total reason. The general pipeline laid in the ground has a temperature less than the temperature of the apartment. Therefore, as a result of the temperature difference on the surface of the pipes, the smallest droplets of water are formed.
How to get rid of condensate on pipes.
If you have metal pipes in the bathroom or toilet, then annually produce their painting. Important! The paint should be applied only when the cold water is disabled, and the pipes should only be dry. The formation of condensate on cold water pipes promotes a constant leakage of water from a drain tank toilet or through a mixer in the bathroom. The constant leakage of cold water contributes to maintaining a low temperature of the surface of the pipes. Therefore, to get rid of condensate on the pipes, it is often sufficient to eliminate the leakage from the drain tank or repair the mixer.
If condensate is formed on cold water riser, then the reasons may be the same, only by the neighbors. For this, quite at night, when there is no large watership "Listen" the pipe. If you can hear how water is constantly noise, then your neighbors are all the case in a faulty plumbing. As long as they do not fix their waterproof reinforcement, you will be condensate on pipes.
The following reason for the formation of condensation on pipes, reinforcement and flushing tanks due to the fact that in the room there is increased humidity. Normal is considered humidity 40-50%. Spend a small experiment: Leave the door to the night open in the room, in which condensation is observed. If the in the morning the pipes are dry, then it's a bad ventilation.
Check out the exhaust ventilation. Submort the fanning lattice sheet of cigarette paper before cutting it into several small strips. If the paper does not move at all or only weakly fluctuates, it means that the case is in bad performance. If there is a looseness in the ventilation box, then you need to eliminate them. Ask your neighbors like ventilation work, if we also recommend contacting the management company. Let them take action: the air duct will be cleaned, they will install a deflector on the roof over the exhaust ventilation pipe.
If passive ventilation does not work well or is not enough, then you can mount exhaust ventilation on the place of the grille, which can be turned on both forced and automatically configuring the inclusion from the timer or hygrometer (humidity sensor).
To get rid of condensate on pipes, you can wear them into a special insulating material.
However, if such is not at hand, you can use the following advice: buy a mounting foam, a corrugation with a diameter of a little more than your pipes, which is cut in length and dress it on a problem pipe. Then the interlock space is filled with mounting foam.
In most cases, the methods of which we told enough to get rid of condensate on pipes. We hope that reading the article you found out why condensate is formed and what needs to be done in order to get rid of it.
A source